Suspension/Handling/Braking

5,114 Total Topics
25 Showing
21 Page 21 of 205
Topics in Suspension/Handling/Braking • newest topics first
3 posts • Started by azian_advanced
hi:D From my expiriance from playing with konis on(toyota carina) stifer rear end maks fwd handle more like rwd, so 3 post strut-bar and stiff rear m...
12 posts • Started by Galcobar
135$ for drilled Brembo discs for the front is that even worth it? 6 gen...
5 posts • Started by BonzaiCelica
20mm Adjustable Rear BTR82Z...
11 posts • Started by BonzaiCelica
???????? The whiteline part is for ST205, why would suspension techniques make an ST205 one? Technically noone has one?...
5 posts • Started by JDUB
brake lines are brake lines. you wont find many reviews of them on here. As long as you are buying the right model lines for the caliper, there should...
4 posts • Started by BonzaiCelica
How much "travel" will a proper coilover have while cornering and hitting small bumps or dips on the road? I know it's an odd question but I feel that...
16 posts • Started by Box
Do you think 205's would stretch at all with 7 inch wide wheels? I'm hoping they won't be too much. I'll going to be running 205/50/16 on my GT4 wheel...
4 posts • Started by ILoveMySilly97
I took it apart and put it back together with the same noise. Ots making that "helicopter" noise....
2 posts • Started by smetjet
Hi there, just received my Apex lowering springs (-3,5 cm), oredered them in UK and they get good revieuws. They have to be fitted now......question i...
6 posts • Started by Malek
10" up front will be way to big to fit, and probably even so in the rear. From what i read the 18x10 have a +25 offset, which is massive. Depending on...
1 posts • Started by Swsupermoto
Looking to set the suspension up for track use. Anyone know good settings for a beams st202...
5 posts • Started by ILoveMySilly97
Also if you buy "spacer adapters" which have another set of lugs built in or go with extended lugs the pitch/thread is 12mm x 1.5 This post has been e...
9 posts • Started by Chovies
Anything and everything to be honest, from what Ive learnt looking around there's the disks + calipers ? At this stage im just figuring out how costly...
13 posts • Started by block
Hello 6gc community, I installed a set of M2 springs on my celica awhile back and it did not drop at all it stayed the stock height. I know, I know mi...
21 posts • Started by FrankB2
^^ What he said. I doubt you'd have any problems with blowouts. Personally, I'd just line it with some rubber cement over the exposed wire and call it...
14 posts • Started by delusionz
dont do it, keep them all the same size...
28 posts • Started by BonzaiCelica
6g Celica's I think are the most forgotten car in the market. I mean most products will come Honda, Nissan, suba.., etc.... but even for celicas its g...
4 posts • Started by Galcobar
Front struts are rebuildable, meaning you only have to replace the shock dampener cartridge rather than the entire strut. Makes for a cheaper repair. ...
7 posts • Started by ILoveMySilly97
Don't you want a bit of preload if running low setups? Less movement... The dial for shock stiffness is only for the initial shock, not how far the wh...
4 posts • Started by Galcobar
Check the emergency brake system. A surprise found by a few people with clunking in the rear brakes is due to one of the pins for the hold-down spring...
4 posts • Started by Nihil
I noticed that when I drive around and come home, my rear left brake smells of hot metal. Then I noticed that the disc is very hot, while the right on...
10 posts • Started by BonzaiCelica
BUZZING!!!! That's the right word. Just wanted to make sure that is was functioning normally....
4 posts • Started by azian_advanced
Hi all! bit of a odd question.. iv heard that a st185 strut will bolt up to a st202 hub? anyone confirm this? the reason i am asking im building a st2...
1 posts • Started by TRDweaponX
Hello, every one. Im planning to put a set of coilovers on my car and was wondering what size tires and wheels you guys would go with. Im already runn...