Suspension/Handling/Braking
5,114
Total Topics
25
Showing
104
Page 104 of 205
Topics in Suspension/Handling/Braking •
newest topics first
How do i cut those little rubber and where to i place them?thanks....
Anyone have any ideas?...
http://gooparts.com/php/search/spread.php?...dxname=gp_parts...
Here is the deal, I want to buy rims that are 18x7.5 with a 42mm offset. Do you think that offset will work with my car? It is lowered 2".All of your ...
New upgrade is coming on my car
and I have few noob questions about springs
:
Why some springs are narrow and "even" and some are not? Is there any re...
hahah yeah im riding on those right now.. there not that great but i like how my car looks.. im just using them so i can save up and buy full coilover...
I feel your pain on the sway bar bolts, I just changed my struts / shocks and I thought it was impossible to remove. Luckily I got the two bolts conne...
Does anyone have sites bookmarked where to buy parts for the st205. I need sway bars and the figure 8's. My old computer crashed and I lost all of m...
dont buy cheapy stuff...
Dang you must have hit that pothole pretty hard to have your tire bubble like that! Everyone loves new tires, enjoy em...
Bam there you go..not my favorite look but they will do till i get my gts wheels.
This post has been edited by
Shocker
: May 4, 2007 - 10:38 AM...
mike, you'll need to cut and re-weld the nut in place, if you can.
my cousin just went thru this on his duece.
the rear crossmember for that runs 600+...
H&R does not have a 25mm only a 20mm....Ill keep looking.....EDIT...foudn them in 25mm...=]
This post has been edited by
Daftboy
: May 1, 2007 - 11:36...
235/40's on 17x8 +35 work great even lowered...probably the best setup for the 6th gen...
I didn' thave much luck with them.. I had airbags and was of -4 and -3 degrees in the front.. after camber plates.. I went to -3 and -2.. so it wasn't...
could it just be build up or sumthing on the rotors since i haven't driven it for 4 months while at school? and it should go away after a bit of braki...
Good find. Craigslist is my friend as well, thats where I got my rims for CHEAP!...
Hi all. I have recently checked out front brakes on my mate's newly bought GT4 and really liked what i've seen - bigger disks and much bigger calipers...
A Celica is a Celica. They didn't make them longer or wider than what everyone else has. Jap spec or not, it would run flush at ~ +35....
Anybody?...
before i ask my question i want to explain what spiring rate is..
Spring Rate is the amount of weight needed to compress a spring a certain . Springs ...
http://cgi.ebay.com/ebaymotors/JDM-CELICA-...113289124QQrdZ1
check out the rear struts on that page. it looks very much like the rears on the non gt4 ...
Eh, my steel rim is bent and thus the reason of why my steering wheel shakes like a lil b1*ch. I am looking for a steel rim for my car 95 Celica ST. I...
Anyone have an aftermarket driveshaft (half shaft/axle)?...
QUOTE(goferris @ Apr 25, 2007 - 7:29 PM) [snapback]550598[/snapback]
ZENN Lowering Springs
http://www.6gc.net/forums/index.php?act=Se...ighlite=%2Bzen...