💬 Phr0z3n664's Topics
Fitting cone filter to tubing - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Oct 3, '02From Va Team 6gcCurrentlyOfflineReputation:1(100%)
What do I need to fit my cone filter onto tubing, it is slightly larger than the tubing?
I had been using duct tape temporarily, but that is kinda ghetto and unattractive.
I had been using duct tape temporarily, but that is kinda ghetto and unattractive.
6 replies
Topic ID: 9834
Sputtering prob - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
My engine started leaking oil bad, so i replaced the valve cover gasket, and spark plug seals yesterday. My PCV(from Intake manifold to Valve cover) was brittle and broke, so i plugged the holes for t...
3 replies
Topic ID: 9738
tire wear - 6G Celicas Forums
6th Generation Celica
› Suspension/Handling/Braking
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
I have a question about the tire wear on my car.
I needed to buy some new tires a few months ago, and within 3-4000 miles they are bald on outside of tire on the driver side, and on the inside of the ...
I needed to buy some new tires a few months ago, and within 3-4000 miles they are bald on outside of tire on the driver side, and on the inside of the ...
5 replies
Topic ID: 8489
off-topic, but I need to express my joy - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
I know this is definitely off-topic, but I just had to express my joy!
I finally finished setting up my recording studio in my house! w00t! I finally got a chance to move all my mixers, P.A., amps, dr...
I finally finished setting up my recording studio in my house! w00t! I finally got a chance to move all my mixers, P.A., amps, dr...
4 replies
Topic ID: 812
CF Hood and pins - 6G Celicas Forums
6th Generation Celica
› Exterior Styling
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Ok I am wondering if the CF hoods made by VIS for our 6gc's require hood pins. If so is there any company that makes the hoods that don't require them
3 replies
Topic ID: 666
Two things happened - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Oct 3, '02From Va Team 6gcCurrentlyOfflineReputation:1(100%)
I finally ordered my combat FB from allbodykits.com, and should hopefully have it in a week or so. I will take some pics and let everyone know how much of a biatch this bumper is to get ready before I...
6 replies
Topic ID: 6608
Put in my new bulbs - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Sep 22, '02From DetroitCurrentlyOfflineReputation:0(0%)
I needed a new low beam bulb so I just decided to replace all the headlight bulbs at once. I picked up some Cool Blues for the lows and Silvania Silverstars for the highs.
I noticed a big difference, ...
I noticed a big difference, ...
13 replies
Topic ID: 6445
Taking out a loan for my parts - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Sep 5, '03From Grapevine, TXCurrentlyOfflineReputation:0(0%)
I am thinking about taking out a loan to buy all my body parts, and wheels.
Is this a bad idea? I have been waiting for a chance to finish the exterior of my car.
I want to order the street concepts c...
Is this a bad idea? I have been waiting for a chance to finish the exterior of my car.
I want to order the street concepts c...
19 replies
Topic ID: 6365
FlashOptions.com - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Is Flashoptions.com a respectable place to buy jdm parts from? Or should I go to Jarco Inc.?
Here's the next question:
Will the 5SFE Throttle body fit onto a 3SFE Manifold? or do I have to buy the thr...
Here's the next question:
Will the 5SFE Throttle body fit onto a 3SFE Manifold? or do I have to buy the thr...
0 replies
Topic ID: 5922
Worked on the tranny today - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
My car had been acting funny the past 2 weeks, so I check my tranny fluid and it's burnt to high hell, so this morning I jacked the car up and let the fluid drain.
Notes:
For those w/ Auto tranny GT i...
Notes:
For those w/ Auto tranny GT i...
3 replies
Topic ID: 5917
Zephyr kit question - 6G Celicas Forums
6th Generation Celica
› Exterior Styling
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
How hard is it to remove the front zephyr lip from the front bumper? how many bolts or was adhesive used to put it on, if it is bolted how hard is it to remove, just a few screws or what?
I just wante...
I just wante...
13 replies
Topic ID: 5630
Exel wheel offset - 6G Celicas Forums
6th Generation Celica
› Suspension/Handling/Braking
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
I'm thinking about picking up a set of Exel TZ-5's in gunmetal only prob is wheelmax doesn't give an offset does anyone know what the offset is on these wheels or most Exel rims?
8 replies
Topic ID: 4831
aero mirrors - 6G Celicas Forums
6th Generation Celica
› Exterior Styling
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
I have been seeing these aero mirrors on alot of celica's that are from europe, I was wondering where I could purchase a set, this is from either forgmaan, Z-Way/ Glide, or Gang's Jail. I want these m...
14 replies
Topic ID: 465
Octan booster - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
I went and picked up some octane booster/fuel cleaner kit. I ran it w/ regular gas I noticed a slight difference in performance, it didn't hesitate throughout the gears, and got up to 60 slightly a b...
13 replies
Topic ID: 4470
sick A** Idea - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
I was thinking what if someone molded celica front bumper and rear bumper w/ headlight and tail lights to a Supra. that would be sick as hell, it would definetly be a sleeper look. I am idiot lol
4 replies
Topic ID: 430
Importing a GT-4 - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Sep 28, '02From Lancaster CaCurrentlyOfflineReputation:0(0%)
I've been thinking about this for a while, I really want to import a GT-4 to the U.S. I just want to know the cost for shipping and how hard it would be to get parts for the car. Can Anyone help me o...
12 replies
Topic ID: 409
Louisiana (South Central.. kinda =P) Meet - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
I want to have a meet sometime this summer in Louisiana anybody from the South Central area of U.S. is welcome. help me out lets set a date and time on the weekend.
15 replies
Topic ID: 3956
ss-iii spoiler post ? - 6G Celicas Forums
6th Generation Celica
› Exterior Styling
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Is the SS-III engraved in the spoiler post on the SS-III's if so where can I get those post? if not would the EURO Spacers be the equivalent to them. Also I use my stock GT Spoiler with the post righ...
2 replies
Topic ID: 3943
Muffler came in today - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
hey guys my Tanabe muffler just came in, I'm glad I didn't buy the veilside muffler because it was bigger than the tanabe, and the tanabe is friggin' huge. Everyone told me to go with that muffler, bu...
4 replies
Topic ID: 3867
Muffler - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 20, '02From Covington, LaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Sep 22, '02From Mammoth CACurrentlyOfflineReputation:0(0%)
I can't decide I heard both the Veilside and the tanabe sounds good, so what should I get?
10 replies
Topic ID: 3629
Showing page 1 of 2 (39 total topics started)