What do I need to fit my cone filter onto tubing, it is slightly larger than the tubing?
I had been using duct tape temporarily, but that is kinda ghetto and unattractive.
If it's not wayyy too big, like a 3 inch filter ona 2.5 inch pipe... then just clamp it down. If not, buy a new correct sized filter. They're not that expensive.
"It's ok to be naked girl... I'm an artist!"1995 AT200 Celica ST:stocked out daily driver...1984 AE86 Corolla GT-SR5:silvertop 20V 4AGE project car jacked up with goodies...1991 SW2x MR2 n/a:bare bones hardtop model soon to be...
No there is a black rubber piece that is supposed to go between the tube and filter, and I do not have it, it does not come with the K&N Filter.
It is like an adapment piece that uses a clamp. I have seen it on all aftermarket intakes and custom made one, but I do not have it and need to know where to get it.
i think autozone sells the adapters for like 30 buh
[img]http://photos-081.facebook.com/n6/081/n15913038_30266081_3342.jpg[/img]
for 30 u can buy a new one with adapter on it.
All I have in this world is my Balls and my Word and I'm not breaking em for no one,- Tony MontanaTeam 6gc 2005
i bought a plumbing fitting.... $12 canadian
it goes from 3" to 2.5" or something along those lines.... its just solid rubber
>