Suspension/Handling/Braking

5,114 Total Topics
25 Showing
24 Page 24 of 205
Topics in Suspension/Handling/Braking • newest topics first
4 posts • Started by Goodwine4
Get Eibach (1" or 1.5"), TRD (1-1.5" depends), or Intrax (1.8-2")...thats really the only ones I would get. This post has been edited by trdproven : O...
6 posts • Started by 199celica
Ack, I missed that. Don't use anti-seize on the pins; it's meant to prevent corrosion, not lubricate moving parts. You want to use the same glycol soa...
2 posts • Started by PaukST
It's quite possible you got a defective pair of rotors, it does happen, if anything try getting in contact with RockAuto and seeing if you can swap th...
8 posts • Started by BonzaiCelica
Any problem reusing stock springs? They should work fine...
22 posts • Started by celica74
^I'd bet he means the Toyota rear strut bar. I have it, you'll like it. A solid rear strut bar is a solid rear strut bar. I hope you got the leathe...
7 posts • Started by azian_advanced
did you have the parking brake on the whole time?...
21 posts • Started by 6strngs
[/quote] How so? I thought you were referring to breaking in pads by getting a thin film of pad on the surface of the rotor which, if you only use pa...
12 posts • Started by BonzaiCelica
hes a hater, watch out.......
8 posts • Started by Bitter
Do some basic tests. Try the rear lock nuts on different studes on the rear. Try the rear lock nuts on the front wheels. Try the front lock nuts on th...
8 posts • Started by Bitter
ball joint fork works great too, but honestly a few well placed hits with a stout hammer usually does it....
34 posts • Started by 199celica
^ Can't tell you what size to go to unless you state the size of the wheel....
1 posts • Started by yellowchinaman
Does anyone have any aftermarket ones? Im looking for a set for my rear GT4....
17 posts • Started by 199celica
BC for ST205 has an optional rear camber top hat you can buy separately has anyone ever looked into adjustable camber arms?...
5 posts • Started by BonzaiCelica
4 posts • Started by richee3
I have to say, I'd read this a few times before I got one. I thought it was all a load of rubbish when it comes to a street-driven car. I chalked it u...
16 posts • Started by BonzaiCelica
AHHH YOU ARE A STUUUDDD!!!! I looked for like 2 hours Nice work Dan!...
4 posts • Started by Nihil
Before I start keep in mind I drive an Impreza RS so 50/50 AWD and front and rear diff's. Now to begin, I will be getting new tires in the up coming m...
21 posts • Started by 3WayStunna
^^ They're rear brakes from a GT4 being fitted on a FWD GT....
34 posts • Started by 199celica
Bonzai - your sway bar is squeaking from the bushing? if you run out of ideas and grease, many like to use teflon and wrap it around the bar and grea...
3 posts • Started by Special_Edy
Hi guys I have a problem with my brakes sounding like there was no pad left but when I checked there was plenty of pad , they scrape when i start in t...
7 posts • Started by Box
Being that I want to start getting into rally cross, and do an events a couple times a year, I want to get coilovers for the car since the stock suspe...
9 posts • Started by jordisonjr
I dont think that this setup should make clunking noises. If your shocks are new then did you replaced and the strut mounts? As for the dead coils it ...
3 posts • Started by richee3
Aftermarket will save money over the OE Toyota struts and usually have a better warranty. How soon are you planning on getting coilovers? New struts a...
5 posts • Started by jordisonjr
Also, when the writing is upside down and the tighter coils are at the top, the springs stands 90 degrees to the floor. If the writings are "readable"...
4 posts • Started by azian_advanced