Suspension/Handling/Braking

5,114 Total Topics
25 Showing
20 Page 20 of 205
Topics in Suspension/Handling/Braking • newest topics first
2 posts • Started by 99celiGT
installed new rotors and pads the other day and it seems one of the bolts that holds the caliper down (not the caliper bracket) has come off and now m...
6 posts • Started by ChristianTRD
All fitted, no problem. Thanks everyone for help and advice regarding fitting. Steering feels tighter and turn in is near instant. Not bad for a stee...
18 posts • Started by Box
Anything but flat black. Mine are flat black right now, with the whole car being flat black. I hate the rims atm, but have higher priorities....
24 posts • Started by BonzaiCelica
A spacer is a spacer. A wheel can fall off regardless of the manufacturer. Most of these brand name companies don't do stuff in-house, they're outsour...
5 posts • Started by Gtdavy
A friend of mine deleted his ABS on his built subaru. All he did was shorten the brake lines running to the ABS and then T'd them at the firewall (eng...
6 posts • Started by bloodMoney
bloodMoney - Definitely agree about the bleeder screws. Planning on replacing the calipers, lines, rotors and pads... Now, the question remains: OE re...
5 posts • Started by playr158
During yearly vehicle inspection the technician noticed that my rear Tein coilovers were leaking and suspension power was 63%/17%. I tried to check if...
13 posts • Started by billkisme
as upright as possible. @ about 2 inches lower than stock.. the little camber that is there is okay with me...
2 posts • Started by Island_Racer
93-98 Supra TT or SC300 assuming you have a ST205...
2 posts • Started by azian_advanced
Hello all. I am looking for more than a year for new coilover locking rings. I have a set of TRD purchased and 2 locking rings were heavily damaged. S...
2 posts • Started by bmj67
1: http://www.6gc.net/forums/index.php?showtopic=66820 2: http://www.ebay.com/itm/CELICA-ST202-ST204...a89&vxp=mtr...
4 posts • Started by njccmd2002
Hi guys, I've realised that the rubber dust boots on my all four of my calipers aren't gonna hold up much longer and want to replace them. Is there an...
12 posts • Started by 6strngs
^what he said. Its usually caused by the suspension. If that tire came into my work we would put a note on the work order saying suspension wear....
4 posts • Started by RavenAegis45
are you just asking if brake pads for our celica's are the same as an avalon/sienna etc?...
24 posts • Started by czwalga
All Australian models came with the full sized spare and raised carpet too...
23 posts • Started by b22ri22an
1st set for sure....
7 posts • Started by acidice333
Best guess: spring twisted in the spring seat when you turned the strut. The rubber squeal you hear is the spring seat insulator compressing between t...
32 posts • Started by 1994Celica
A set of calipers (f+r) alone usually goes for 550-650 iirc. Plus new pads and rotors, you're looking at close to $1000 http://www.ebay.com/itm/JDM-To...
6 posts • Started by bsamps4
+25's will stick out more. I'd get the 25's though. will have to roll fender slightly....
6 posts • Started by aldizzurp
Can't wait for the pictures! I'm deciding on either these Apex's, Eibach's, or Tein S-Techs.. Want a lowered look but not slammed on either 15's or 16...
22 posts • Started by block
^ Suited for 8" wheel....
17 posts • Started by block
Have you found a set yet? I'm considering getting a set for mine.....
11 posts • Started by Batman722
by how much?...
8 posts • Started by BonzaiCelica
Also. I need just calipers for my 1999 gt? Or do I need brackets too?...
4 posts • Started by conus00
Hi All, I have a 1995 ST 1800cc (standard European edition, left hand drive - if that makes any difference). I am planning to upgrade my front brakes ...