So I got a Jspeed front strut bar and I found out it doesn't fit under the stock hood, when the seller said it would.
Does anyone know if it will fit if I cut any of the support braces out?
1995 GT::::Diffusing the Situationエキサイティングカーレーシングチーム!march2010 COTM:6GCfeature2014:january2015-2016-2018 COTM
I have to put it back on to check, but it was between and inch or two I think.
it fits on my stock hood. no problems. are you not able to close the hood? some people have done is install a couple of washers on the hood hinges to elevate the hood from the windshield area giving it more clearance.
Learned a lot in 10 years...I hardly log in anymore, last loginToday Sept 6 2019, and I was forced just to clarify a post. LOLIf you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in2grfe Swapped...Why I chose the 2GR, before you ask read here...A great civilization is not conquered from without until it has destroyed itself from within.@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.
Try the washers first mike, I cut my supporting brackets on my old hood to clear the IC piping and regretted it, it looked to sloppy.
st205 powered ss3 coupe
thats strange, unless there are 2 versions of the jspeed. which i did not know.
Learned a lot in 10 years...I hardly log in anymore, last loginToday Sept 6 2019, and I was forced just to clarify a post. LOLIf you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in2grfe Swapped...Why I chose the 2GR, before you ask read here...A great civilization is not conquered from without until it has destroyed itself from within.@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.
>
QUOTE (njccmd2002 @ Mar 7, 2013 - 12:47 AM)
>thats strange, unless there are 2 versions of the jspeed. which i did not know.
Yes there are.
Do a search and you can see that one version is much higher than the other.
I have the lower, Mike has the higher.
edit, pics
This post has been edited by Batman722: Mar 7, 2013 - 12:03 AM
my st205 swapandour Beams swap
yayyy for meeee....
So will I have to cut out the support braces on the hood and use some washers to bump the hood up? Or just do one of those options?
my st205 swapandour Beams swap
Mine fits fine
98 ST204 ZR - Black Beauty - Roaming the streets of Sydney73 TA22 LT - Tiffany Blue - Mint Classic Weekend Cruiser75 TA22 LT - Snow White - Mint Classic Weekend Cruiser77 RA28 LT - Flubber Green - Mint Classic Weekend Cruiser94 MX-5 NA8 Clubman - Red Racer - Looking for cornersWIP Project: 69 RT40 Corona, 2nd WIP Project: 66 RT40 1600s Corona86 Corona RT142 - Daily Driver6GC 4 Life Baby!!!
