💬 Delta_Phoenix's Topics
New GT-4 in the states? - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Sep 4, '03From Twin Cities MNCurrentlyOfflineReputation:2(100%)
Several people have told me that they've heard Toyota is going to start production of a new GT-4 that will be available in the states. I don't know when, and I don't know if these rumors are true. Any...
23 replies
Topic ID: 9648
Replacing the CV joints - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Last reply: ModeratorJoined Oct 1, '02From fall river, maCurrentlyOfflineReputation:13(100%)
one of my CV joint boots has decided to start throwing grease all over the place. i'm kind of afraid to go searching around for how much a shop would charge to replace them. the parts alone are gonna ...
10 replies
Topic ID: 8624
Question about mounting underbody kits - 6G Celicas Forums
6th Generation Celica
› Exterior Styling
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Just got my StreetGlow Gold Series underbody kit. 130 bucks off Ebay.
Anyway.
It says not to mount it near extreme heat sources. Exhaust would be this. So where do I put the rear bulb? There aren't ma...
Anyway.
It says not to mount it near extreme heat sources. Exhaust would be this. So where do I put the rear bulb? There aren't ma...
8 replies
Topic ID: 8585
Misses when idling/cruising, pulls hard at WOT - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
The Celi finally left me stranded after 10 years of me driving it and putting 160k on it (275k total). Basic rundown:
Died... (OBD1 7AFE, btw)
Checked for spark + fuel. No spark.
Tested ignition coil ...
Died... (OBD1 7AFE, btw)
Checked for spark + fuel. No spark.
Tested ignition coil ...
4 replies
Topic ID: 80674
Troubleshooting a SRT-4, need thoughts... - 6G Celicas Forums
Other
› Off Topic
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Been trying to diagnose a problem on a friend's 2003 Dodge Neon SRT-4. I'll keep this short since we haven't been able to figure much out on this. Basically, the spark plugs are dry and white along wi...
9 replies
Topic ID: 73145
FS: 1994 Celica ST - 6G Celicas Forums
6th Generation Celica
› Buying/Selling
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
I am looking to part with my car that I've driven for the past year and 3 months. I'm wanting a SRT-4 and I will need to sell my car for the down payment.
I'm not pricing just yet, but anyone that's i...
I'm not pricing just yet, but anyone that's i...
4 replies
Topic ID: 7187
'94 ST, possible to pull axles w/o unbolting from the spindle? - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Haven't posted here in ages. But that's cause the Celica hasn't really had any major problems. That's a good thing
Just wanted to know if anyone has ever tried to pull the driver side axle from the C5...
Just wanted to know if anyone has ever tried to pull the driver side axle from the C5...
5 replies
Topic ID: 71422
7A-FE oil pan torque specs - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
My oil pan recently got fubared. SO, I'm replacing it. But I don't know the torque specs for the bolts, and I also believe that one of the holes are stripped. I've looked all over for the torque specs...
5 replies
Topic ID: 6805
Going 7A-FTE at 140k+ - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Sep 9, '02From Scranton, PaCurrentlyOfflineReputation:7(100%)
I'm wanting to eventually do a turbo project on my ST. The only thing is, my engine has about 136k miles on it right now and I won't have the money to do this for quite awhile. I was wondering if you ...
24 replies
Topic ID: 6492
Removing the stock antenna - 6G Celicas Forums
6th Generation Celica
› Interior/Audio/Electrical/Wiring
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
I fiddled around with the stock antenna for awhile trying to get it off, but I never had any luck. Can someone tell me how to get it off?
3 replies
Topic ID: 5939
WTB: Passenger side low beam headlight assembly - 6G Celicas Forums
6th Generation Celica
› Buying/Selling
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Looking for a passenger low beam assembly ASAP!
0 replies
Topic ID: 57026
Anyone have 4age/ae86 experience? - 6G Celicas Forums
Other
› Off Topic
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Sep 30, '02From Washington Spokane / Coeur D' Alene IdahoCurrentlyOfflineReputation:11(100%)
I'm working on an '86 ae86 and I'm having some trouble getting it to run. It'll start but after about 10 sec. it just dies. Planning on buying it IF I can get it to run. Looking for some advice. I'll ...
15 replies
Topic ID: 56492
Mechanical oil pressure gauge on the 7A-FE - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
I went through the trouble of installing a mech. oil pressure gauge on my ST. I drive a lot, just wanted to keep an eye on it.
Well the install was fairly smooth with a little trouble finding the righ...
Well the install was fairly smooth with a little trouble finding the righ...
11 replies
Topic ID: 55080
Which suspension setup? - 6G Celicas Forums
6th Generation Celica
› Suspension/Handling/Braking
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Oct 9, '02From Longmont, COCurrentlyOfflineReputation:1(100%)
I'm getting opinions on what the best setup would be. I was going to go w/ the Eibach Pro Kit and Koni Yellows. I'm not sure how much the TRD kit costs or how it rides.
Any tips?
Any tips?
11 replies
Topic ID: 5400
Canada has the GT4, right? - 6G Celicas Forums
6th Generation Celica
› General Discussion
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Does anyone know if the ST205 was available in Canada? If so, then what would be the difficulty in getting one across the border? I'm getting too used to the SlowA-FE.
1 replies
Topic ID: 52910
Value of an '85 Celica Supra? - 6G Celicas Forums
Other
› Off Topic
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Sep 4, '03From Twin Cities MNCurrentlyOfflineReputation:2(100%)
A co-worker's boyfriend has an '85 Celica Supra. The body is immaculate except that it needs a new hood and passenger fender (wrecked and rusted, but the rest of the car is dent-free). The damage is m...
6 replies
Topic ID: 51361
WTB: Shift Boot & Shifter Insert, M/T - 6G Celicas Forums
6th Generation Celica
› Buying/Selling
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Looking for a factory shift boot in good condition and the shifter surround piece (unpainted preferably, but I won't be too picky) for a 5-speed 6th gen. Dealership prices are outrageous.
If anyone kn...
If anyone kn...
1 replies
Topic ID: 51137
Funky suspension/tranny noises... ready to torch the Celi. - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
So for about 2 years I've had this popping noise. It happens no matter which direction the wheels are turned, but happens less often when turning left. It's inconsistent, and doesn't happen all the ti...
1 replies
Topic ID: 49538
FS: Kicker CVR12 & Rockford 400 Punch Amp - 6G Celicas Forums
6th Generation Celica
› Buying/Selling
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
Selling the system out of my Celi...
-Kicker CVR12 800W max dual voice coil, about a year old, bought new.
-Rockford Fosgate 400W punch amp (rated about 460W) 2-channel 8 AWG w/ remote knob, about 3 y...
-Kicker CVR12 800W max dual voice coil, about a year old, bought new.
-Rockford Fosgate 400W punch amp (rated about 460W) 2-channel 8 AWG w/ remote knob, about 3 y...
0 replies
Topic ID: 47906
FS: White face reverse indiglos - 6G Celicas Forums
6th Generation Celica
› Buying/Selling
Started: EnthusiastJoined Oct 16, '02From Hohenwald, TennesseeCurrentlyOfflineReputation:1(100%)
I've got pictures of the gauges in my profile.
http://www.6gc.net/index.php/action/m_memb...profile/itu/255
The gauges appear green in the pic, but they're blue. They have a switch to change between g...
http://www.6gc.net/index.php/action/m_memb...profile/itu/255
The gauges appear green in the pic, but they're blue. They have a switch to change between g...
2 replies
Topic ID: 4774
Showing page 1 of 4 (62 total topics started)