Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
86
Page 86 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
^ Exactly. The junkyard I'll go to has a week-long return policy, so swap 'er out in the parking lot and if it's no good, bring it right back. I thoug...
Got a pair of vice grips? Spray some Seafoam Deep Creep or PB Blaster and let it soak in for 30 minutes then blast it again and use those vice grips. ...
Ah, gotcha. I read in a hurry earlier. I was wondering why you would ask if there were separate plugs
No, there's just two plugs....
incorrect cam sprocket torque. find a new roll pin at the hardware store in the bins....
^^^ i know exactly what he is trying to do, im speaking by experience. i know where things are on all these transmission.
we adapted the MR2 turbo tra...
I don't know where they go, that's why I asked
I can't see them through the engine bay, and have to pay $ every time I use the hoist. Nothing was disc...
4age will work as well......
Hey guys, so i have been thinking about swapping my 3sfe for a Beams motor near the end of the year. im trying to get some research into it now so im...
Its just like - not using a running car to jump start a vehicle, always use a lone battery to jumpstart to prevent damage to both vehicles computers.
...
Hell yeah dude, Ive checked every scrap yard around here and thats one of the first things they chuck into the black hole pickup truck beds with 50,00...
Need to know if this will fit my 96st with manual transmission. Thanks!
http://www.ebay.com/itm/Brand-New-1-Row-w-...=item43adf8b454
Ok...i can read i...
1995 toyota celica st usdm
i just reinstalled my 7afe after ripping out the ecu wiring harness and motor
replaced the block with a jdm 7afe and used m...
are you sure you have a GT? C52 trans are mainly for A series engines. Perhaps an ST?
Anyway those trans are not that expensive to buy if you can fi...
Hi,
Just wanted to know if i really do need it for a engine swap if converting from a 97 ST 6gc? 0R do the 3sgte engine doesn't need it. Can it run wi...
200-204 yes, 205 no
This post has been edited by
hatchy_gt-s
: Apr 17, 2012 - 10:51 AM...
650 to 750 rpm is factory spec....
I understand everyone and their mothers have posted about swapping or whatever, but I was wondering waht exactly will be needed to do a swap into a ST...
hold on, you were interested in a SRI, are you wanting looks sounds or? because i got a TRD drop in filter before (which i removed right away), never...
Answer:
The throw out bearing likely went bad.
That's very common. But before you condemn it, get someone to operate the pedal while you observe the c...
Anyone know the part number for this? I need a new one. My plugs are filthy...
I suppose you could always fill the torque converter and put it on the trans in preperation of installing the transmission. Then dump a few quarts of ...
hey guys,
i was wondering if anyone knows if the 5SFE exhaust system setup is the same as the ST185's set up? would the angle on the piping be the sam...
BEAMS sounds like the engine for you. Parts can be difficult to source but not too bad. Give me a little bit and I'll post the wiring up for you.
Edit...
Get an alignment. A caster problem can also prematurely wear your wheel bearings. Have you been changing one side at a time?...
First, I'd pull all 4 spark plugs and spray a little WD-40 into each cylinder. Do this just because the engine has been sitting for a while with at le...