Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
53
Page 53 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
at that price you can convert your car to a legit GT-four....
checked leads,plugs and filters, all good, what has got me is that I parked the car overnight, started it up and to have this problem, especially when...
im having a hard time understanding what you did.
like mentioned if its a 5 speed, the trans is the same all years...
are the clutches interchangeable on the gt four ?
This post has been edited by
hzawde
: Aug 13, 2013 - 7:40 PM...
Been looking at starting the purchases for my build. To start I am searching for the the e153 lsd trans. I have found a few on ebay and what not but...
. Otherwise, you car will either not idle properly or more likely will not run at all. In this case, you'll need to rotate the crankshaft pulley 2 rev...
1st gear to 2nd gear car will shake/splutter around 16 mph, 2nd to 3rd car will shake/splutter and so on basically every gear. Um around 5 gear going...
any clutch for the 3S-GTE will work.
I suggest Southbend....
"High flow" and "quiet" are both relative to the application and to the listener respectively and are both opposites to each other in an exhaust syste...
Dunlop makes 205/55/15 from tire rack. I just bought tires from them.480 shipped to my house...
Another update:
That's the part number for it, and it costs $75 new from Toyota... It's the same as on a lot of other Toyota SUVs of the same generati...
For the cost of turbocharging or supercharging you'll easily match or surpass the cost of a V6 swap. For the most part the 7A is a stout and resilien...
Been researching transmissions for a few weeks now. Here is where I am sitting.
Auto Out of the question
I am building power, and its hooking up to a...
Blew a rod....
That out of the way, I'd just look for another project. Unless you're buying it just for the shell and transmission to swap in a diffe...
everything was just replaced this past winter. Im going to just throw in a new rotor perimeter seal with some fipg and see if that does the job...
Btw, you meant the engine would shake like as in it would stutter like its about to stall?...
If the engine wouldn't crank how did you check for spark? The engine has to be spinning to check spark....
Anybody?...
4th gens from 2001 onward should be able to be converted to OBDII, as they'll be set up for EOBD/JOBD which is essentially OBDII.
This post has been e...
where do i bleed it from? is there more than one spot?
thank you...
A bad heater core would make sense, as it could perhaps let out water vapor which would be your "white smoke".
This post has been edited by
Box
: Aug ...
http://www.6gc.net/howto/determine_check_engine_light_codes
Find out what the code is. I'm thinking perhaps a bad MAP sensor....
Aisin is THE oem manufacturer for most parts on these cars...If my oil pump wasn't mounted to the block I would show you the really stupid reasons why...
And here's how:
http://www.6gc.net/howto/determine_check_engine_light_codes...
All of the sensors and fan switches can be tested with a multimeter and a pot of water. Functionally, only the engine coolant temperature sensor and t...