Suspension/Handling/Braking
5,114
Total Topics
25
Showing
48
Page 48 of 205
Topics in Suspension/Handling/Braking •
newest topics first
Becareful on the "behind" rod not to twist it in any directions. This will throw off the stering of the vehicle....
10-15mm spacers all round and you shouldnt rub on lowered ride height (depending on tyre choice)...
^ Okay, fine. But do you have any semblance of ride quality or proper adjustability?
This post has been edited by
SwissFerdi
: Jun 30, 2010 - 2:58 PM...
hmm
May? Have to do or not? With the car up and the bolts off the suspension comes down, right? Then, maybe, i have to look up if everything comes wit...
I know that there's a how-to, I've read it several times, but it talks about grinsing something and saving bearings, but when he was talking about coi...
suspension techniques
i hope to getting some soon...
If its not stamped on the back of the wheel you can do some simple measuring to find out.
First measure the width of the wheel.
Then place the wheel f...
Does a bigger offset mean the wheel will stick out farther? As in, will a wheel with a 45mm offset stick out farther than one with 42mm, or is it the ...
depending on what got bent, sometimes the places where the a arm meets the frame is bent also. So inspect the mounting spots and see if anything else ...
apparently rear disc celicas are a rarity... broke a bolt while changing my brakes and rear caliper hardware is even harder to find then rear disc pad...
hi guys im a little confused wut struts i have. just bought some lowering springs and i needed new struts awell so heres the problem!
rebuildeable str...
i don't have any experience but i think you'll need some sort of dynamic simulation program and create a model with the chassis, suspension components...
^ One to three weeks, typically. Mine were settled after two.
This post has been edited by
SwissFerdi
: Jun 22, 2010 - 10:05 AM...
^ and spacers haha...
....... i wanna see the flushness
or im not satisfied....
McPherson for sure......
get the whole rear brake assembly of a gt lines also then read this
http://www.6gc.net/howto/convert_rear_drums_to_discs/3
This post has been edited ...
They'll be sucked in a little bit but it still looks good. I am lowered on tien s techs( about an inch in the 1.5" in the front and 1" in the back) an...
Decided to get some new rubber a couple of days ago.
Did a little online research and decided the best tyres for my budget were Nexen N2000. Found a p...
got it...back to the search engine once more...maybe a couple of times searching over, maybe ill be lucky to find his post. thanks for the thoughts...
Got the old bushings out but can't get the new ones in.... does the inner ring get knocked out or is it one solid piece??...
^ your absolutely right! Right down the the adjustment height locks and also the plastic shock covers it has one. Im quite curious now...
^ Dont listen to him that is one of the most dangerous and damaging things you can do/get, I mean while your at it why dont you just cut them...
Anywa...
Bilstein suspension does exactly what it was supposed to do and that is why it is not offered on most cars. You are putting a sport suspension which i...