Forced Induction
3,483
Total Topics
25
Showing
22
Page 22 of 140
Topics in Forced Induction •
newest topics first
hey guys, just wondering where to tap in on the gen 3 3sgte WRC for my MBC install. i searched but couldnt find any info on where it goes and what oth...
90-degree bends are the equivalent of adding roughly 8 feet of additional piping to your exhaust setup. Dual exhausts gain no flow value when coming o...
Hey guys, have an issue ever since start-up last May, on my 94 GT, st 205 engine, it starts but dies.....if i start it and hold the accelarator at ar...
first guess would be a dirty idle air controller. its located under the throttle body...
im pretty sure the 3s blocks are about 99% the same in those areas but im not completely sure....I believe the changes were made in the head and aroun...
actually the last one was for soulend...just tryin to help out....
read my thread, Blow-by sucks...get ready for new piston rings
This post has been edited by
Neon90424
: Sep 22, 2011 - 6:09 PM...
- Use a E153 transmission. Again, same as above. Do your research and find out why....
^^ i agree. But a speed density system measures vacuum....
Getting toward 300 bhp is getting near the limit of your stock fueling system, but you should be fine with the standard equipment for now. If you plan...
Also here is a question... I dont have a hard line for the master cylinder I installed for the clutch.. whats can i safely use to run from there to ...
Good info ;-)...
denso....
AEM was lot good review did see to much with st205 ,
Power FC is 414AT001 part number ? and are add sensors needed with the 3rd gen 3sgte ?
This pos...
Eh Rav, ordered a PowerTek boost controller, its coming from the UK, should take just over a week to get here, it says it comes with detailed instruct...
I have a 95 Celica GT4 ST205. It was imported from Japan to UK, and someone has changed the clocks to MPH. However, for quite some time now, the speed...
[/quote]
do you not need lower compression pistons when boosting low with either turbo or SC?
[/quote]
Only if you want to run large amounts of boost....
HA! I love the fake K&N filter XD...
hey everyone, so... for some reason the new Walbro 255 Fuel Pump I'm using is too large for the bracket... has anyone put this pump in an ST before? I...
Before this began happening I was in the process of changing out my old turbo for a rebuilt turbo because mine went bad. So, while i was waiting for ...
anyone know of some turbo's for the 3s, that will push some good power? i have been looking around but have had no real luck. im looking around the 3...
242 for the devilsown but no tank stage 2 340...
I have been searching for these things everywhere. Called every dealer (nissan chevy, honda, toyota, etc), every auto parts store, even the diesel aut...