Engine/Transmission/Maintenance

14,249 Total Topics
25 Showing
177 Page 177 of 570
Topics in Engine/Transmission/Maintenance • newest topics first
1 posts • Started by 6gsillyca
I have noticed a clunking coming from underneath the front of my car. I can feel it through the floor while coming to a stop on both the pass and driv...
7 posts • Started by 6gsillyca
either replace the boot or the entire axle. if you leave it and drive on it, the crack will spread and spray axle grease on the underside/wheel wells....
2 posts • Started by BeefyT
http://www.6gc.net/howto/reset_your_air_fuel_ratio To reset your mix. Worked for me....
33 posts • Started by 808celica
dONE!! putting the motor was a PITA!!! and the rear mount was a bitch too. pics have a little pridicament though friggin leaking gear oil right where ...
2 posts • Started by Bitter
So I am getting ready to get some new plug wires and i'm for sure going to get the NGK ones from importrp.com - My only problem is that they have two ...
6 posts • Started by k-weaver
7th gen short shifter there just high enough were the handbrake doesn't bother you. fits perfect its not that bad of a install prob takes about an hou...
3 posts • Started by laff09
check to make sure its not your heat shield clankin the exhaust....
16 posts • Started by 56willysnut
808celica, So your saying i should just go buy a whole new axle instead of just replacing teh cv boot? Would this still be cheaper then paying someone...
9 posts • Started by Bitter
Actually that's the first mechanic who managed to find the bloody fuel filter without me pointing it out for him after 5 minutes of searching. Neverth...
8 posts • Started by Bitter
Alright... I have been having problems with my car sputtering and stalling out on me for a few weeks now. This only happens after the car is brought ...
2 posts • Started by 808celica
K by the voice of my dad im keeping the car (mixed emotions) and gathering parts. Going to get a new clutch fork, support, and clip. There's a type A ...
4 posts • Started by blu94gt
Answered my own question, swapped back to the original filter and everything seals up tight. Going to return the filter tomorrow and get a Toyota one...
9 posts • Started by Mstoochn
just lookin around at some 3s swap stuff and i am curious, does the 3rd gen use an FMIC or is it stock top mount?...
31 posts • Started by 97lestyousay
Any updates?...
43 posts • Started by Badkarma
a friend of mine got the red 96 auto running. and not overheating. just had to be burped.. there was quite a bit of air that needed to get out. tried...
30 posts • Started by bdub215
8hp? Damn, I was going to say maybe 2hp and some bling factor in the engine bay....
2 posts • Started by Candiiman
hey guys ... the other day i was driving out of the dealer and ... as i accelerated, the car made a weird squealing noise.. and when the noise happene...
1 posts • Started by white97
for anyone who's done the 4a swap, what kind of exhaust setups are you running? im having a few issues and i think my down pipe that conects to the ca...
8 posts • Started by ETNRIDER
[quote name='TrdPnoy' date='Jun 22, 2009 - 11:15 PM' post='780928'] Hey everyone.. I need to replace my motor and I can't find any 5sfe off a 6 gen ce...
7 posts • Started by DEATH
did you ever wind up getting your radiator from these guys? How was the service? Were you satisfied? I'll be in the market for a new radiator soon, an...
4 posts • Started by Rider
I need to change my flex pipe 'cause of some problems I had before that damaged it. How much should it cost to change it? I'm trying to not get ripped...
12 posts • Started by 92-gt
anybody?...
11 posts • Started by jimmykay
[facepalm]...
5 posts • Started by azian_advanced
also check your battery connections....
6 posts • Started by BonzaiCelica
Before the intake manifold? Do you know of a link that can show me where?...