Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
149
Page 149 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
basics,
mileage? clutch,
slave cylinder,
check the levels....
I'd like to preface this statement with the fact that I am an Electrical and Computer Engineer from Worcester Polytechnic Institute. I do have some ac...
**** if you want a 2.4 swap a 2az lose weight in the process and boost that....
17650G VALVE, DUTY VACUUM SWITCHING
90910-12149...
Hi Everyone....need some help with this one....
My car Failed its MOT today - only on emissions... the CO is way too high... maximum allowable is 3%??...
Alright so sorry in advance if this has been covered somewhere already, I tried searching and couldnt find what i was looking for. I just got my injen...
4a is a great engine... in a corolla, or even those 95 subaru imprezzas... i don't like them in celicas. i'd say save up for a respectable 7a swap or ...
about 2 cups of coolant is disappearing every 200 miles from the radiator.
I have a brand new radiator that came with a new cap, i put new hoses. The ...
QUOTE (GilVilla @ Mar 23, 2010 - 5:04 PM)
What is the normal pressure of the fuel pump on a stock Celica GT 2.2, my car has 42 PSI is that good?
Thank...
Hi there fellow Irish Beams owner here.
Did you replace the MAF with another Beams MAF or another Toyota/Lexus one? They are sensitive to changes in ...
all right, thanks....
I'm working on a beams motor. It's been installed and starts up, but i have a check engine light. The check engine light does not come on right away, ...
@delusionz:
Would an e-manage ultimate help in controlling the ACIS in both RPM and throttle openning?
As for my intake, it's a CAI setup already.
For...
any idea on pricing art?...
MR2 or celica 3S-GTE are all going to have teh same mounting locations on the engine...
Anything not NGK or Denso will make your car run not the way it suppose to. Especially imports. I've experienced it with many of my cars.
Just recentl...
any engine pin out diagrams?...
After much testing, it would appear to be the Fuel Pressure Regulator.
It would jump to 52 PSI when you removed the Vacumn Line, which is 8 PSI higher...
does anyone have a pic of a gen3 3s-ge fuel rail!...
Does someone know how to check or test the oxygen sensor? the car has 2 oxygens sensor one on the top of the header with one 1 harness wire (white) an...
did you disconnect the battery after you did all dat to erase the code and drive around...
94-95 Has OBDI
96-99 Has OBDII
add diagnosis sensors and computers to that list....
Do you really need a 3 jaw puller to pull the crank shaft pully off ?? I have a 2 jaw puller and its just not budging at all......
Getting back on subject, I dont think there is any piggy back that can raise a rev limiter, if there if please show me.
This post has been edited by
k...