Forced Induction
3,483
Total Topics
25
Showing
13
Page 13 of 140
Topics in Forced Induction •
newest topics first
A basic gen 2 swap is around $1200. Always prepare for the worse though....
Ahh your injector table huh, All I have on my power FC is a XY axis graph of Injector Lag Vs Voltage and a Injector % starting at 100.0. When I upgra...
Anyone on here supercharged a 6th gen or know someone who has?...
1/8 BSP and 1/8 NPT are very close. the oem sensor is just for the dummy light. you can re-tap it for 1/8 NPT and clean out the hole and screw in your...
engine: gen III 3sgte powered by autronic SM4 ecu, walbro fuel pump and stock injectors
This is my first time starting this engine since I bought all ...
^^
Mike,
Been doing a lot of reading on the GFB g force 2. That thing sounds amazing man. I wouldn't be suprised if the price on it doubles, after the...
>click here<
That link is to pressure2 (a moderator here) who did a 5sfte. Very in detail. In his 3sgte swap thread he says the differences in the swa...
3VZ-FE will fit just as difficult as the 1MZ-FE into the ST chassis. The 3VZ is heavier and comes with less HP than the 1MZ-FE I believe.
But yes, if ...
Please delete.
This post has been edited by
Bladey
: Jan 28, 2013 - 8:38 PM...
Cool thanks. Never used the stuff before....
Can some either take a picture of their vsv pinout (what color the wires are on each pin), or post a pinout of it? I'm thinking it doesn't matter whic...
apexi makes good pippybacks. a series should match up to a series....
AEM Dry Flow filters...
Do you have the stock water - air change cooler? if so no point in getting a front mount as this is proven to be very effective...
Anybody on here try the Haltech?...
Anyone know how to hook this up? im going from a aftermarket bov to a factory one that has two vaccum lines at the top instead of one?
A diagram would...
Car = Gen3 3sgte + aftermarket ECU + individual coils/distributorless setup (only using distributor for timing)
I have a question..but to get you on t...
check if its a tappered thread, if it is, then its a BSPT, if its not a tappered thread, chances are its either M10x1.25 or M12x1.5
make sure your thr...
272 cams would help you get there in exchange of more lag, at least a 10whp increase and more when properly tuned.
couldn't you push a couple more PSI...
are you going to bypass the EGR? you could easily tap plugs in the new manifold to support those lines. you need a line coming off the manifold to the...
Hi folks,
Im actually an MR2 owner retrofitting a Chargecooler into the Tubby
Everything is there that I need but I had a few questions about the pump...
A lot of GT4 people use Mitsubishi Evo Intercoolers, you can pick them up on ebay pretty cheaply....
dont you wish everything was that easy?...