Wait so you need the carrier bracket for the axle? I might have one, not sure though. I'll check tomorrow.
Rhode Island Project Celica - 6G Celicas Forums
>
did u use spacer on each side ?
i had hard time whit these front hybrid axle and now i need to bring back my passenger cause the rubber crack all around and grease went away.
how big was the spacer u put there ?
it logically cannot pop out if there is spacer enought big...
(dont drive whitout carrier axle )
This post has been edited by Needles: Jul 10, 2011 - 10:32 AM
QUOTE (LimitedGT4 @ Jul 9, 2011 - 9:12 PM) 
>So my axles jus keep poppin out
Used a spacer
Longer axle from camry
Longer axle plus spacers
Keeps poppin out
Tryna get an axle carrier but everywhere i go no one seems to know what it is lol
Havent been able to enjoy my car for more than a few mins at a time lol
any suggestions anyone?
Used a spacer
Longer axle from camry
Longer axle plus spacers
Keeps poppin out
Tryna get an axle carrier but everywhere i go no one seems to know what it is lol
Havent been able to enjoy my car for more than a few mins at a time lol
any suggestions anyone?
did u use spacer on each side ?
i had hard time whit these front hybrid axle and now i need to bring back my passenger cause the rubber crack all around and grease went away.
how big was the spacer u put there ?
it logically cannot pop out if there is spacer enought big...
(dont drive whitout carrier axle )
This post has been edited by Needles: Jul 10, 2011 - 10:32 AM
you need the axle carrier from the turbo MR2.
The set up is similar to the 5s but you need the MR2 part.
The carrier bolts to the back of the block and the axle has a bearing on it that clips into the carrier with a snap ring.
The set up is similar to the 5s but you need the MR2 part.
The carrier bolts to the back of the block and the axle has a bearing on it that clips into the carrier with a snap ring.
my st205 swapandour Beams swap
Lol am tryna get one wth no luck guess ill have to hit the junkyards sucks that i aint got time all week to goto them if anyone has a spare one let me know
Lol funny thing i asked a friend who has an mr2 turbo and i asked him about the carrier and he said he didnt remember havin one on his car n that really confused the sh*t out of me
This post has been edited by LimitedGT4: Jul 10, 2011 - 1:29 PM
Lol funny thing i asked a friend who has an mr2 turbo and i asked him about the carrier and he said he didnt remember havin one on his car n that really confused the sh*t out of me
This post has been edited by LimitedGT4: Jul 10, 2011 - 1:29 PM
whitout the carrier u can move the axle a little bit, i noticed when i swapped, it maybe can damage the teeth of the axle...in some kind of way
Yea i know i had a carrier it jus ended up being the wrong one so now i need the mr2
SO my axle stubs look like this no snapring on the tip only a Cap ring? i guess it can be called
and YES
the cap ring IS ON (dont know if thats the proper name as it looks like a cap)
guess the problem is the axle carrier
outside of damaging the axle stub which i have a spare for i guess i could also mess up the
differential i guess or should i not worry about that?
AXLE CARRIER NEEDED ASAPPPPPPPPPPPP JAJAJAJAJAJAJAJAJAJAJAJAJAJAJA
anyone knows if theyr easy to find in junkyards or is that one of those parts they usually dispose of
This post has been edited by LimitedGT4: Jul 10, 2011 - 12:48 PM
and YES
the cap ring IS ON (dont know if thats the proper name as it looks like a cap)
guess the problem is the axle carrier
outside of damaging the axle stub which i have a spare for i guess i could also mess up the
differential i guess or should i not worry about that?
AXLE CARRIER NEEDED ASAPPPPPPPPPPPP JAJAJAJAJAJAJAJAJAJAJAJAJAJAJA
anyone knows if theyr easy to find in junkyards or is that one of those parts they usually dispose of
This post has been edited by LimitedGT4: Jul 10, 2011 - 12:48 PM
I couldn't remember if I had a carrier or not. most of the stuff I do is on the driver side. That doesn't have one for sure since it's too short but I do remember a snap ring near my spare engine on the ground. I'll try and source you an axle carrier. I know a local, dan, on the mr2oc parting out his car this weekend. Oh. and were BOTH axles popping out? were those the two axle inners I sold you?They don't look familiar(all trying to remember from memory so i might be wrong) They should have a groove for a snap ring. They look like this. You could see the ring that I'm talking about. These are e153 inners 
This post has been edited by qtfsniper: Jul 10, 2011 - 1:28 PM
This post has been edited by qtfsniper: Jul 10, 2011 - 1:28 PM
dont remember the driver side but passanger side is like pic, the one i got from u and the one from the junkyard are like the pic i posted and after u mentioned the snapring i started wondering y i didnt remember seeing one and its because its like that,
anyways thanks Treit for helpin me with the carrier
an no only the passanger it jus pops out enough to lose grip from the diff
This post has been edited by LimitedGT4: Jul 10, 2011 - 1:25 PM
anyways thanks Treit for helpin me with the carrier
an no only the passanger it jus pops out enough to lose grip from the diff
This post has been edited by LimitedGT4: Jul 10, 2011 - 1:25 PM
just waiting for a reply from Dan. He's in worcestor
thanks man i appreciate that alot, this freakin axle is givin me depression jajajajajaja
itll all go away with my first full drive
itll all go away with my first full drive
The driver's side inner axle has a clip on the end, that's how it's held into the tranny.
The pass side uses the carrier bolted to the back of the block (similar to the 5s) and with a snap ring on the bearing on the axle shaft it's held into the carrier and that's how that side stays in the tranny.
The pass side uses the carrier bolted to the back of the block (similar to the 5s) and with a snap ring on the bearing on the axle shaft it's held into the carrier and that's how that side stays in the tranny.
my st205 swapandour Beams swap
So my friend Triet is the man i should.have an axle carrier in a few days and my gt4 breaks came in today finally now all ill need is raiser blocks if i decide to go for.the huge wing which am still.debating althogh i know ill love it once i gettem lmao hahajahahahahaha
Gt4 heaven here i come
Gt4 heaven here i come
congrats Jose.
my st205 swapandour Beams swap
>
Thanks Dustin
QUOTE (Batman722 @ Jul 11, 2011 - 10:26 PM)
>congrats Jose.
Thanks Dustin
Hey dude, update everyone on the project! I'm curious also
Lol ive been thinkin about that dyno
Well update my tranny went party my fault paty bad tranny
Converterd the awd tranny just finshed installing it toda
will test drive in mrning and have a field day
Could not get that damn snap ring on that holds the pass axle
Well update my tranny went party my fault paty bad tranny
Converterd the awd tranny just finshed installing it toda
will test drive in mrning and have a field day
Could not get that damn snap ring on that holds the pass axle
>
was it difficult to do?
QUOTE (LimitedGT4 @ Sep 10, 2011 - 10:47 PM)
>Converterd the awd tranny just finshed installing it toda
will test drive in mrning and have a field day
will test drive in mrning and have a field day
was it difficult to do?
st205 powered ss3 coupe
>
Not at all
I can try n put sumtin together for you if you wanna attempt it
I also have a spare VLSD for anyone interested and the other
E153 for parts
QUOTE (Ted95 @ Sep 21, 2011 - 8:41 PM)
>>
was it difficult to do?
QUOTE (LimitedGT4 @ Sep 10, 2011 - 10:47 PM)
>Converterd the awd tranny just finshed installing it toda
will test drive in mrning and have a field day
will test drive in mrning and have a field day
was it difficult to do?
Not at all
I can try n put sumtin together for you if you wanna attempt it
I also have a spare VLSD for anyone interested and the other
E153 for parts
>
pm'd im intterested in doing this since im takin my car off the road for the winter anyway
QUOTE (LimitedGT4 @ Sep 22, 2011 - 7:40 AM)
>>
Not at all
I can try n put sumtin together for you if you wanna attempt it
I also have a spare VLSD for anyone interested and the other
E153 for parts
QUOTE (Ted95 @ Sep 21, 2011 - 8:41 PM)
>>
was it difficult to do?
QUOTE (LimitedGT4 @ Sep 10, 2011 - 10:47 PM)
>Converterd the awd tranny just finshed installing it toda
will test drive in mrning and have a field day
will test drive in mrning and have a field day
was it difficult to do?
Not at all
I can try n put sumtin together for you if you wanna attempt it
I also have a spare VLSD for anyone interested and the other
E153 for parts
pm'd im intterested in doing this since im takin my car off the road for the winter anyway
st205 powered ss3 coupe