>
QUOTE(creis @ Nov 28, 2005 - 5:10 AM) [snapback]360348[/snapback]
>
install is very easy, 10-15 min job.
steps:
1. remove old bulbs, (unplug and twist out)
2. convert new harness (you get 2 cables, red/black wire each, take the white end and snap out the wires by reaching in the open end and pushing the tab out with a small flat head or something, then pul wire back (not easy but not hard)) then pop em back in, in reverse.
do both cabels.
3. plug the newly modded cable(s) into the cars headlight connector.
4. mount the ballests I screwed mine onto the wheel well but that only works on the pass side if you dont have an >>aftermarket exhaust>> (since the factory intake box takes up the wheel well space) had this problem with Djspikes, ended up just zip tieing it to the frunt cross bar thing and leting it basicly hang right behind the light.
5. install the bulbs, MUST NOT TOUCH THE BULB the oils form your skin will boil on the glass and cause it to burst when its on. take off the cap holding it by the wires, and put it in just like the regulars came out, kinda hard to get it to twist but do it softly and just work it in it does fit.
6. connect the input cable (one you modded) into the ballast, and plug the HID bulb into the ballast's output wirs (opposites connect together.)
7. once you have both sides done zip tie the wires down out of the way, and fire em up, you'll hear a hiss wile they warm up and will see the light kinda weak at first but as the hiss goes away they get brighter.
enjoy.
Do you mean aftermarket intake?
on Step 4
This post has been edited by djspike: Nov 28, 2005 - 4:02 AM