Interior/Audio/Electrical/Wiring

7,599 Total Topics
25 Showing
89 Page 89 of 304
Topics in Interior/Audio/Electrical/Wiring • newest topics first
3 posts • Started by audet2604
i bought a remote for my celica and to set the remote if i find the security system controle unit .and i dont find it ,if you say where is it plz pm m...
8 posts • Started by garry62be
[thank you,great site,it's a great car if i could cure the rattle thats around pillar/dash!...
6 posts • Started by bccentaur3
i was thinking about removing my dash and center console along with the pillars to get it alll fiberglassed and moded. my question is how hard is it t...
8 posts • Started by ar-t
Hi to all, thats my firts post in here, im from spain and excuse me my english is too bad. I have the same problem, butt there's located in the column...
8 posts • Started by BonzaiCelica
For your safety sake, get a crash bar. (are you talking about not having it with the 96 bumper or not having it on the car itself?) Otherwise you just...
20 posts • Started by DEATH
gauge doesnt matter just so long as its no tooo small. connect a wire from the chassic of the car, then run it to your neg....
3 posts • Started by sbrile
I just installed a new radio and electrical antenna. Aftermarket antenna. Everything was working great and antenna beatufully. So I started my car ...
3 posts • Started by cheela
Hi Guys, I've just pruchased from eBay the leather version of my 3 post steering wheel, airbag version. I want to swap them over bu how can I do this ...
7 posts • Started by Malek
Does anyone know what that means? ^^ I have the same problem and didn't want to make a new thread haha...
7 posts • Started by bseaman_5
are you talking about the harness on the trans? or the fuse? Other than that, you just go in reverse, that turns on the lights....
5 posts • Started by bmj67
does anybody know if the front and back seats out of the new celica gen7 2000 onwards would fit into the gen 6 st202 94-99 celica's i like the look of...
2 posts • Started by bmj67
as far as I know you just have to remove the seats, the center console, the door sills and the kick panels to replace the carpets....
6 posts • Started by Batman722
anyone??...
7 posts • Started by crankyelbow
^ All wires must match the power handling. Remote wire is the only one that doesn't matter....
6 posts • Started by Akirad1
hey again lads. so recently I was drivin out on the curvin roads of the ranges and i decided it would be great to have the wind in my hair so i crank ...
6 posts • Started by crankyelbow
but its more complicated than just 'taking them out' or putting them back in for that matter. there are a few things that need to be wired. i just don...
9 posts • Started by garin
Glad I could help!...
16 posts • Started by 6gsillyca
fcd?...
18 posts • Started by 6strngs
all you need to do is pull the airbag fuse thats in the engine bay. i had the same problem and it fixed it just fine. hope that helps...
4 posts • Started by ej8ferio702
All fogs use H3...
12 posts • Started by 92-gt
group buys must be approved by a moderator and should be in the For Sale section with the heading GB AFTER being approved by a mod... i would defini...
7 posts • Started by 92-gt
It is worth a shot. Every once in a while you can come across high output ones on ebay. You may have to splice the wires due to the plug differences.....
7 posts • Started by 92-gt
Hmm, not a bad idea.. Good thinking man!!...
1 posts • Started by Richie_st
Just need abit of help, i bought a new alarm for my Gen6 ST and when i sent it to someone to be fitted the guy said the original toyota alarm would ne...
16 posts • Started by bccentaur3
Factory Fitted Alarm (Maby) but is definatly the central locking unit to work with the Factory Key. I found this in my car as well took it out and the...