Suspension/Handling/Braking

5,114 Total Topics
25 Showing
85 Page 85 of 205
Topics in Suspension/Handling/Braking • newest topics first
4 posts • Started by 6_GEN
bought these rotors of a ebay, are they reliable, will they fit the 95 celica st, My Webpage also where can i find good calipers? mayb someone has a p...
17 posts • Started by 94TRDcelica
^ I think you should take it back and tell them about the shaking. It sounds to me like the wheels aren't balanced properly. If your rear tie rods wer...
9 posts • Started by GriffGirl
5 posts • Started by Hanyo
does the noise increase with speed? i'm thinking wheel bearing.......
80 posts • Started by 6_GEN
^you should be able to get calipers (using ur 6th gens are cores) from advanced auto....
17 posts • Started by 6_GEN
definitely don't cheap out on your suspension....
7 posts • Started by DEATH
car pulls. apparently my brake isint releasing, so one side's brakes were still somewhat engaged, while the other side wasn't, thus pulling the car to...
6 posts • Started by alltracman78
cool, going to see my mechanic tomorrow. will do the wheel bearing test. not 100% sure on the engine + awd swap plan. tweak made a post saying he wan...
7 posts • Started by azian_advanced
^ apparently the part numbers for the right side are registered trademarks ® ™...
7 posts • Started by njccmd2002
hmmm I guess I am the only one who ever needed a hub...
5 posts • Started by Celiracer18
i have the teins and mine dont rub with 215/35s im getting some 225/40s this spring so we'll have to see on that...
12 posts • Started by 808celica
Check your belts too! Open the hood and get someone to drive slowly with you along side to try to identify where the sound is coming from! Jsut realiz...
10 posts • Started by 94TRDcelica
Call your local dealer. Give them your vin and see if you have the sport suspension or not. Since you have a 99, you should have sealed front struts. ...
13 posts • Started by 808celica
Could be the clips or the pads. I've gotten a pair that just had a bad tab on the edge. But if your missing clips then i think its safe to assume that...
3 posts • Started by bccentaur3
Are stock gt and st springs the same? can they be swapped? This post has been edited by supra12big : Mar 6, 2008 - 11:56 PM...
3 posts • Started by alltracman78
If it's all the time you probably either have the heat shield rubbing the rotor or the clips for the caliper brackets rubbing the rotor. Did you bleed...
5 posts • Started by Coligion
how bout sillcone spray?...
3 posts • Started by 94TRDcelica
I've just got exactly the same issue! It occurred upon installation of my new clutch! The garage fitting it (A respected suburu motorsport garage) sai...
5 posts • Started by bccentaur3
Def - part numbers are in the JDM P/N sticky. I have one and it works rather well....
5 posts • Started by LewFX
10.9...
4 posts • Started by GriffGirl
Anybody here know if Nexen N3000 is a good tire? What about Federals, or any others? We do not have that much choices where I'm at. Thanks!...
5 posts • Started by dabazied
A few questions for ya...... 1st, is it only when you turn right? 2nd, is it just at low speeds? 3rd, is it more of a rattling sound or series of cont...
6 posts • Started by 94TRDcelica
I found the thread for the guy who makes the 3point, I was blind! Does anyone have a link to the thread regarding how to fir the neon strut to the 6gc...
20 posts • Started by 6_GEN
18" are for the looks, it's all it is about (unless you fit some crazy ass wide tires)....
3 posts • Started by alaNi
grease your strut bearings...