Suspension/Handling/Braking

5,114 Total Topics
25 Showing
82 Page 82 of 205
Topics in Suspension/Handling/Braking • newest topics first
3 posts • Started by Badkarma
a set new from the dealer is about $80...
8 posts • Started by 808celica
how many cambers are in a set? what did you pay for them and where did you get em?...
3 posts • Started by bccentaur3
Hey The shafts that are on a st202 LHD, are they the same as the shafts on a RHD? Hope for quick reply...
5 posts • Started by 6strngs
actually adjusting it is not hard at all. you loosen an nut, spin it, and tighten the nut back down. but, again, make sure you're using an alignment r...
2 posts • Started by stylez94gt
I have Nitto 555 225/40/17 ZR...
5 posts • Started by gottaknowmo6gc
aint bad in my opinion...
7 posts • Started by 6gsillyca
ahhh well actually thats wat i thought, so the half shaft is better right? what do half shaft run for?...
4 posts • Started by 95CelicaST
best advice is to get rid of those cheap ebay springs and put your OEM springs back on....
3 posts • Started by 6_GEN
Howdy guys, anyone know of a good place to buy brake rotors for the GT online? I tried doing a search but no luck for the 6th gen. thanks!...
30 posts • Started by 808celica
^ When I put my s techs on, they said my camber was at the very most allowable negative camber that would, i guess you could say, pass the allignment....
10 posts • Started by 808celica
gt's dont use shoes they use pads. it wasnt this hard to get mines off. dont ask my how and why i took my rotors off on all 4 sides. i just wanted to ...
5 posts • Started by 808celica
#1: Some pads squeal til they get totally seated. Many other possible reasons why as well, but it is probably that they aren't seated totally yet(dep...
9 posts • Started by hurley97
does anyone have a clue if 225/50/17 tires will fit on my st.. my friend will let me get them for free but i dont want to unless they fit...
24 posts • Started by bccentaur3
Another section of tie rod end. I chopped off 2" of the US tie rod end, made sure the threads were good, chamfered the outer edges (to make a nice gro...
4 posts • Started by njccmd2002
hey guys im new here i was wondering if any of you gt4 guys are running any other types of brakes besides stoc or big brake kits basically i need to k...
7 posts • Started by 6G96GT
buy the rubber ring that goes on the inside too, u need a 14mm with a long extension, rotate the spindle as you take out each nut...
16 posts • Started by alltracman78
Also, I cannot find this gasket from toyota... they have no idea what i'm talking about... Any idea's on what to use to close this thing off? (i'm thi...
15 posts • Started by aznpnoiboi55
Buying on ebay is only going to get you quality things if as a BUYER you are smart and selective. I've bought many parts off ebay, all have been good ...
2 posts • Started by Batman722
I have an ST and my boss found a st18x celica with rear discs. Will those fit my 6gc?...
3 posts • Started by alltracman78
Alright ill check that stuff out. thanks for the help...
5 posts • Started by azian_advanced
i see. it's not that hard. just have your buddy hold the brake pads in while you put the caliper on. you can let go of the brake pads once the cali...
6 posts • Started by 99GT
can't do a group buy due to the non-guarantee of them having the product. they're from a used parts dealer. sorry....
24 posts • Started by _mikeE
Bushings are what connect your suspension at certain points. They're usually rubber which is squishy. Polyurethane bushings are basically solid. Unles...
8 posts • Started by 94TRDcelica
even out of warranty its still cheaper to buy a new one than to get it rebuilt? dang that sux...