Suspension/Handling/Braking
5,114
Total Topics
25
Showing
41
Page 41 of 205
Topics in Suspension/Handling/Braking •
newest topics first
Get new belts and tighten it up better...
as long as you have the SuperStrut suspension then Yes you can use it, Im pretty sure TRD only made SS coils...
$1,000 for used Cusco coilovers? I'll pass....
Basically you have two options. Either get the sealed strut, or just the cartridge insert.
The idea behind the cartridge is that IF your strut is rebu...
18x9.5 0offset front -5offset rear........beware alot of work is needed to make this fit...
Check the tightness of the strut bolts....
dustin knows what he's talking about lol...
alright alright thx sounds good...
hi 6gc lovers!
I must go buy some new tires, im running 17 inch whells, so i need to know the bigger size of tires i cant put into it without problems...
1) Purchase coilovers
2) Install
3) set rear higher than front
4) ????
5) Profit....
could also be bearings....
Depends on what you are going for. Hawk pads are about the best thing you can do for a factory brake system, in my opinion. They will be a little hars...
As stated If I am going from st brake set up to gt and want to get ss brake lines do I find them for the st or for the gt?
Thanks guys
This post has b...
I have the D2 coilover set and they are basically the ksports repainted, not a single complaint about them they are great. Rides rough, but hell they ...
205/40/17
This post has been edited by
mak5603
: Feb 7, 2011 - 2:27 PM...
i need the inner and outter diamaters of the rear springs please.
trying to buy a quarter inch spacer and i cant remove my rear spring to check atm...
Center bore of what???
You dropped your car, get alignment no matter what. Alignment for those who dont know isnt just camber, alignment is a combo of...
-5 and -3?!?!?! mine are only -1.15 on both sides with camber adjustment bolts even then there is still play to adjust it a bit top and bottom before ...
i already have cusco front, rear strus and an underbrace. tanabe coils
i really want this product!!
same question as bonzaiCelica : are those j-speed ...
Everything I have listed I already have waiting to be put on car unless otherwise noted (have the DF210 springs already)
3vz-fte swap is in the future...
I've seen 18x10 work on a st185. I know these are completely different chassis, but on the offset guide thats stickied 9" wide wheels wont fit regardl...
Dude if i were you i would get the C-ONE FRONT AND REAR...or there is also this company...
http://www.laile.co.jp/eng/product/parts/c...i/towerbar.htm...
Hello,
Excuse me if I'm not supposed to ask this here, but it's about the same manufacturer (from Poland) and the same material (polyurethane): I want...
Does anyone know what the Parking Brake Control is?!
I'm redoing my whole parking brake setup because one side partially froze on me and I'd rather ha...