Suspension/Handling/Braking
5,114
Total Topics
25
Showing
29
Page 29 of 205
Topics in Suspension/Handling/Braking •
newest topics first
Ive been having major problems with my lower control arms lately. The bolts that thread into the frame in the center of the control arm (largest bushi...
Been looking into coilovers to do my suspension right the first time. I dont want to slam the celica just have it handle better and take curves better...
Are you sure the piston is sliding slanted or are the slides frozen and it's just conforming to the angle of how far it can move the slides? As long a...
All the same......
can i use the front brake line from st to replace gt rear brake line?...
been looking for a set myself. where did you find to order them if you dont mind me asking?...
just get the GT rear disc conversion, i guess you can get upgraded rotors, calipers, pads, but all that is unnecessary if you don't plan to use it. I...
Hey guys, so I've done my 3rd gen 3sgte swap and kept the 5sfe front wheel drive tranny, I believe it's the s54 transmission I think???
Anyway, when t...
Hello all.
Anybody else notice that without any kind of dust shield between the rotor and the wheel that everytime it rains the rotors grow a nice lay...
also does any one have any input on the twin pot pistons with some ebc brakes pads??...
cool thanks for the input guys. im trying to find a tire that will bite and these seem to be one of the better options. i can probably live with a sli...
Almost everytime you remove you suspension and reinstall your alignment will be off. Most shops can get by and bring it back to spec given the tech kn...
found out what it is , i need a figure of 8 joint and a straight lowwer arm...
^ Of course they'll fit, but the OP will require GT calipers....
As long as everything is installed rite just take some sand paper sand down the inside of the rotor and then use a rubber malet to get them on....
Does anyone know what size brake lines we have?
I think it's somewhere around 1/8 or 1/4 of an inch.
My rear drivers side line pretty much blew so I'm...
go to autozone......
Always nice when it's the cheap and easy fix....
could go with a one off wheel.
Contacting companies like Mackin Industries and asking if they would custom drill wheels that usually come in 5x114.3 t...
actually I found these. Anyone know if I can trust this to be brembo authenticity?
http://www.ebay.com/itm/Disc-Brake-Rotor-B...bed&vxp=mtr...
Go read the flush wheel fitment thread and that will give you the information you need on picking out a staggered wheelset....
^^ lol...
Alright guys got it all fixed! Had no bump stops, put new ones cut on notch. Also put in properly! Thanks guys for your help! Got a noise in the rear ...
I'm sure this has been asked before, but I didn't see it anywhere... Do the brakes on the ST205/GT4 fit a ST204/GT Celica? I am looking to upgrade the...
^ That's proper information right there. Thank you....