Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
142
Page 142 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
Did you look under the hood for the cruise control fuse? I'm fairly certain it's in that box. I could be mistaken though....
as long as it is the same motor and compatible, and has clearance to mount it will fit on the manifold side but from there you will have to figure out...
Did the plug look bad when you replaced it? Many different possibilities here. I'd start with the easy stuff which it sounds like you may have already...
buy & replace the "a/c magnetic clutch"...
Hi all,
I am replacing the INtake Air Temperature Sensor on my 1994 JDM ST-202. Unfortunately, the some clown had super glued the connector to the se...
^ the first cat goes away but you can still plug in the first sensor, did you plug back yours? I never got anything related to the o2 or catalytic a...
6gc's dont have clutch cables. We have hydraulic clutches. I'd try bleeding the clutch at the slave cylinder, that might help the "loose clutch" feeli...
^ *squeeeeeeeeeeeaaaaaaaaaaaaaaaaaaaaal* *vrooooooooooooooooooooooooooooooooooooom* *chpsch* *sexy Ferrari sounds* *sexy Supra sounds* *vraaaaaaaaaaaa...
94- OBDI here...
Delta camshaft in Tacoma. Go over on pstoc and shoot them a message. They are a vendor over there. Jon the owner will answer all your camshaft questio...
I have a 97 Celica GT 2.2 liter. I found these cam gear on ebay and want to know if it will fit my car. Has anybody have cam gears before on their car...
.......so what was the problem?...
check the how-to...
if that number 21 is what you need, that's called fuel pump bracket, and there are 2 part numbers for it
23206-74720
77203-20190
they are both for the...
Alright. I'll try the Pensoil synchromesh tomorrow and get back on here and tell you how it goes.
Thanks for the help....
^ good enough for me. I think I'll stick with the mobile 1 I already have in there
thanks for the replies!...
I have a 1996 Toyota Celica ST. I am wanting to do an engine swap. I dont know what to put in it. I don't want anything too expensive and I want to be...
Check shifter cables first. Make sure the pin is on right and everything. Not pinched.
Stop hard-dogging it all around town.
Then if either of those d...
94-95 or 96-99?
is it cranking? (or trying to atleast) or nothing from key-turn.
and if it is cranking, do you have any funny smells?
This post has be...
actually the stock 7th gen shifters are an upgrade over the stock 6th gen...
hi i have an st204 and iwas wondering if the apexi n1 st202 system would fit on mine, i have been looking for a system for a long time and have had no...
Hey guys,
I was just wondering if there was a gasket between the distributor and the block? I just got a new distributor in the mail that has no gaske...
Hey guys i really wanna do a v6 conversion to my car, and i think its really really difficult but i heard it wasn't all that bad, so I'm looking for a...
get a caldina 3s auto, and a auto tranny from a V6 camry, if I'm not mistaking, the ecu will be able to control that transmission....
i have a leak somewhere. I have tried the dyed chemicals to try and trace it, but couldn't find it. There is radiant coolant coming from the passenge...