Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
114
Page 114 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
I have read all the sticky's and posts etc, but have only found info on the 2grfe swap.
I'm guessing this is a better engine than the 1MZFE engine. Bu...
Ah, I read it but I missed it. sorry.
So now, you have fuel pressure but are the injectors getting a pulsed ground and power? Is the ignition coil get...
95 gt convert...
just replaced the radiator, is there suppose to be pressure from the hoses, i trieed squeezing it to make sure its working properly. fans wont kick on...
Hi guys I am trying to find out if there would be any difference in the distributor of my 94 celica gt with 2.2 liter 5sfe motor and another type of t...
i have a 95 celica st. it needs a transmission. will a transmission out of a gt fit. thanks...
Do not know if anyone will ever find this useful (and being I own a 94, I sure don't), but I came across this while searching for an answer for a ques...
Awesome Sauce. Now post pics of your car...
all GT mounts/brackets except the front mount.
This post has been edited by
Batman722
: May 13, 2011 - 10:20 PM...
Hi all
I have a 1994 st202 which Ive had 9 years,but noticed recently when i first start up i get a noise very similar to a dry bearing noise coming f...
Guess I'm on my own thanks anyway..
This post has been edited by
Lone_Wolf
: Apr 19, 2011 - 4:29 PM...
check engine light=no.
well, sometimes i get a (can't remember the code) "engine idle above 3000 while not in gear" or something like that. but the li...
Can anyone tell me the torque specs for the flywheel bolts and also the tranny bolts that go into the engine? I just need a quick answer, and yes I se...
Cheers guys, Yeah celica's are pretty common over here but heaps of 3sfe
Ye i would perfer to get a gen 3 but they are quite hard to find and redline ...
don't need to wind it out all the way, just some hard acceleration will do it. A good romp when getting on the highway from the ramp will do it well e...
Hey, I've had a rattle for a while and it changes every now and then, it usually only rattles after a gear change in high rpm. I had to change the pow...
Done a search but could not find what I was looking for..
Just need to know if you need a pulley puller for the idler pulley on the accessory belts, n...
could it also be the EGR valve? my car is doing the same thing, 7afe auto trans. i plugged a comp in and it gave me a triggered sensor in my EGR....
but when it finally does fire (after say 5 - 10 cranks) it runs like there was no problem.. wouldnt it never start it there was such a problem?
and so...
Check that the sensors are working properly....
are we comparing beans to apples.
you cant compare two dissimilar engines.
any N/a engine will be easier to install, any n/a engine easier to upkeep, ...
did you change the pump seal? if its comming out where you say it is it should either be the pump seal or the input shaft seal that you replaced, so i...
I need a gen3 alt bracket and a guy responded to one of my posts on the mr2 forums saying that he has a gen2 3SGE alt bracket. I am pretty sure they a...
could be a clutch going.. but more than likely you need clutch fluid & a bleed...
Ask
Hardtarget
for pics or info....