Hey, everyone i got a bit of a situation here, i have a 1994 ST with the 7afe motor and automatic transmission, anyways when i was driving the car out of no where the car started slipping into neutral so i decided to pull over to check stuff out, luckily i did, the car was "pouring" out transmission fluid and yes i did make sure it was transmission fluid not motor oil. and seriously it looked like i was taking a quart of tranny oil and just pouring it out on the ground, it was that bad not exaggeration either, i wish i was though
. anyway right after this happened i got a call for a job offer, and i have an interview very soon and no way to get there. hopefully someone can help me figure this out soon! so heres my story i replaced the input shaft seal, and i put the tranny all back in the car and well it still leaked, so i pulled it back out again this morning and i cant see any cracks in the transmission either. So does anyone have any ideas on what it is? i dont have a job ... well yet and i have only $100 left to fix the car so let me know what you guys think i should do, thanks!!!! ill post pics if that helps?
Overview of it.

I was told this is a breather hole, and this is where the fluid comes out at.

This is the new input shaft seal i replaced.

This post has been edited by rapid3642: Apr 12, 2011 - 3:08 PM
Overview of it.

I was told this is a breather hole, and this is where the fluid comes out at.

This is the new input shaft seal i replaced.

This post has been edited by rapid3642: Apr 12, 2011 - 3:08 PM
