I have been looking into inlet manifolds for my project build and came across this.....

http://www.burtonpower.com/jenvey-turbo-pl...et-apsc-70.html

The cost is by the by, but i have a few questions......most importantly, wouldnit fit and in what orientation would i need to put it? I would measure up myself but dont have an engine yet!

Secondly, would it be best to use a cut down 3sgte inlet manifold or use a 3sge inlet manifold?

I have looked at racerx manifolds but they look too home made to me, i would make one myself if i wanted the home made look :lol:

Dahlback racing also do a great looking manifold, but it would need cutting up to get it to fit, its also bloomin expensive :rofl:

Any other suggestions/ ideas?

I am not interested in a Caldina side feed as they always seem grossly over price d to me.