I have a pair of oem TRD coupe rear splitters. A very rare find. Doesn't fit my hatch and these only fits on coupes, currens, or convertibles. It was stock red but I sanded it down and repainted it silver. Only downside is, it has a small crack shown in the picture. I broke off one of the mounting brackets but still have it in hand. It'll still hold. Just need some 3m double sided tape to hold it up. Or rivet the bracket back in place. I'm asking $150 shipped or trade for a hatch TRD rear splitters.



Not noticeable.


The missing bracket. [photo taken from eBay]


This post has been edited by ILoveMySilly97: Jul 16, 2013 - 3:56 AM

Looking at the pictures, I'm not so sure those splitters actually are for a coupe... The coupe splitters are quite a bit longer. I think they're about 2" longer than liftback splitters. I can't find any side by side pictures for comparison, nor pictures of liftback splitters on a coupe or vice versa. Are these splitters the same set as this thread?

Yea. Those are it. Some reason I mounted it and it didn't fit.

So, having read the thread that richee3 posted here, these in fact are not coupe/curren rear splitters, they are regular st205 splitters that just didnt fit your car?

>

Yea.......I'm going to go back to that thread and close this one until further notice.