Hey guys,
Ive installed one of thos aem fuel pressure gauges on my dash and have it wired up, only thing is, I wonder where to tap the pressure sensor.
Any tips on where anyone put theirs? I can make a part (like a "T" bracket) to put it anywhere pretty much, just wondering where is easiest so i can focus (by the regulator or by the entrance to the rail....or wherever else...)

thanks.

This post has been edited by Island_Racer: Jan 9, 2013 - 11:52 AM

you want the sensor in the rail before the regulator. you will have to play around with fittings to get something that works.

this is the banjo bolt that feeds the rail. if you can find a fitting that supports this banjo and also has an 1/8 NPT (your pressure sensor) then you should be good to go.



This post has been edited by Smaay: Jan 9, 2013 - 1:28 PM

so basically this....

http://www.ebay.com/itm/Russell-640700-Fue...bc2&vxp=mtr

do you know the size banjo bolt (12X1.25??), so i can pull and replace same time?

thanks man

This post has been edited by Island_Racer: Jan 10, 2013 - 9:40 AM

its either 10 or 12

12x1.25

may aswell get a fuel regulator too while your at it, will have the port for the gauge/sender