First off hello first post and 2nd this is my 1994 celica st im 23 years old had it since i was 15 and sold it at 18 bought it back 5 years later exactly as i sold it minus a working engine and tranny : ( any way. i replaced both and the car ran great for 10 miles and lost compression. Now what id like to know will any 7afe engine fit no matter vin code or will i have issuse i would like to get the newer engine that has a b vin i think mine says a

This post has been edited by huntsmcgee: Jul 24, 2012 - 11:45 PM

yes any 7A-FE should work, just use your manifolds and sensors and accessories

I will agree. Any 7a will work. 96 and up do have an extra sensor but you dont have the wiring for it so youll have a connector without anything to plug into it. But itll be fine. Get er dun

>


Hi. I just finished an engine swap in my '94 st. My 236k mil 7afe(a) died, I replaced it with a newer 7afe(b) engine from a JDM Corolla. I had a couple plugs that are different, or have nowhere to go, because the harnesses are diff but the engine still works. car runs GREAT. Any specific questions, just let me know.

>

jappan doesnt have emissions regulations like the us. so your harrness has emission component plugs. bet you have an egr connector dangling dont you.

This also means any 4a, 5a will do the same correct?

Explain in more detail what you are asking please. All jdm motors dont have emission components like egr. So yes a JDM 4a and 5a would not have extra bull crap bolted on. i believe the 5a was only introduced in the japan market correct?