Over 1M Posts • 84K Topics • 9K Authors

WTB: Engine and Front Suspension Bits - 6G Celicas Forums

Topic #83333 9 posts Started by qatar11
I need:

* 5SFE distributor (The one with the Coil inside / Pre OBDII)
* Hubs in good conditions
* a pair of knuckles - Condition of ball joint is not important
* The coolant pipe with all the sensors attached to it.
* 5SFE / Celica GT Drivers and Passenger Half Shafts (Original Toyota Equipment Only)
* Drivers and Passenger Low Beams
* Drivers and Passenger Front Fenders as well the supporting sheet metal that sits under the headlights

* Under Engine protective plastic

Thanks for everyone's support!

This post has been edited by qatar11: Apr 27, 2012 - 3:29 PM

-Mikemjcoury@gmail.comTeam Reynolds StyleCelica BlogCelica WikiIt will take him a moment to realize that he's about to make a 180 degree turn at speed, but you will be ready for it. Brace for the g's, and fast heel-toe work.
*bump*

-Mikemjcoury@gmail.comTeam Reynolds StyleCelica BlogCelica WikiIt will take him a moment to realize that he's about to make a 180 degree turn at speed, but you will be ready for it. Brace for the g's, and fast heel-toe work.
nobody selling? 0_o

-Mikemjcoury@gmail.comTeam Reynolds StyleCelica BlogCelica WikiIt will take him a moment to realize that he's about to make a 180 degree turn at speed, but you will be ready for it. Brace for the g's, and fast heel-toe work.
I have both the passenger and drivers side cv axles that came off my celica st (94). FWD. Will they work for you ?
>
QUOTE (BoostedRicer @ Apr 27, 2012 - 4:10 PM) *
>I have both the passenger and drivers side cv axles that came off my celica st (94). FWD. Will they work for you ?


Sorry - wasn't clear - GT Half Shafts only - Updated the original post.

-Mikemjcoury@gmail.comTeam Reynolds StyleCelica BlogCelica WikiIt will take him a moment to realize that he's about to make a 180 degree turn at speed, but you will be ready for it. Brace for the g's, and fast heel-toe work.
I have a complete front axle, Passenger side from a gt.
It is used, but was still in good condition when I took it out.
Wasn't clunking or leaking.
Took it out because a shop told me it was making a clunk, so I replaced it, and it turned out that the noise wasn't from the axle but from something else.

-Protection mode, For when your amp tries to blow its load.1995 Toyota Celica GTS-Daily Driver1999 Chevy Cavalier-Winter Beater1994 Honda Civic CX Hatchback-DeadMy Celica!
Bump - still looking!

-Mikemjcoury@gmail.comTeam Reynolds StyleCelica BlogCelica WikiIt will take him a moment to realize that he's about to make a 180 degree turn at speed, but you will be ready for it. Brace for the g's, and fast heel-toe work.
I have the dist your looking for
sending a pm now

95 gt coupe, v6 swap weekend toy99 gt hatch beams swapped wife's94 st hatch my daily driverhttp://www.6gc.net/forums/index.php?showtopic=82235n
>
QUOTE (qatar11 @ Apr 23, 2012 - 11:30 AM) *
>I need:
*
* The coolant pipe with all the sensors attached to it.

I saw a couple of these at the junkyard today. Do you need the sensors w/pigtails also, or just the pipe?