Hey everyone,
I was wondering what people do when keeping the hood stock and keeping the WtoA intercoolers? do you cut the hood frame so it fits? or hammer it down?
also if you could post pictures of what you've done that would be great!
thanks,
Kevin
some guys installed washers at the hood hinges to lift it up a bit.
Learned a lot in 10 years...I hardly log in anymore, last loginToday Sept 6 2019, and I was forced just to clarify a post. LOLIf you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in2grfe Swapped...Why I chose the 2GR, before you ask read here...A great civilization is not conquered from without until it has destroyed itself from within.@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.
I did this...except there is no WtoA I/C. But I don't think this is the answer you were looking for.
This post has been edited by match220: Aug 18, 2011 - 3:57 AM
-Jay95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve
