I need help installing these fogs, is there any other way of installing them without taking off the bumper? I have the bolts but its a very tight squeeze to mount the bolts up

Also what did you guys wire them up too? thank you

well....i have a 94 with a facelift cover. I removed the cover to install fogs. It wasnt that hard, and it gave me space to pick grounds for the fogs. I wired mine up to the parking lights(solder n heat shrink).

I believe you can get in there by removing the bottom plastic guard. itll be tight so you would try to use the right tools to get to the crash bar to bolt on to. Make sure you just bolt on the brackets only first. fog lamps are connected last while you are in front just like you would be changing your bulbs if they were burnt.

alright ill try that, i figured i could pull off the plastic underbody piece but well see, thanks guys

There are little tabs on the bumper cover that go on the underside of the crash bar. I took a Dremel and cut the tabs back where the foglights sit to expose the mounting holes. No cover removal required.

right not too hard, i actually removed my bumper when I did it but thats a lot of bolts to remove before getting to the fogs.

This post has been edited by trdproven: Feb 1, 2011 - 12:48 AM

Does anyone have the diagram of where all the bolts are located? i heard its tricky also to get to some of these screws

The stickys have a section on how to remove bumper step by step.