Thanks for the advice...i will peel off that stupid sticker, and the motor will be powerwashed and detailed...the car sat for over two years out side...I guess that the guy ran out of money and his friend who was working on the car died...it became a mouse n snake nest out in the corner of this guys property!!!! I bought the car as you see it in my profile for $1350.00...i have taken the interior out of the car to give it a good cleaning and shampoo the carpet and seats...the trunk is all apart and was bleached and cleaned today The car smells horrible!!!...i had to replace the fuel filter and the fuel pump to get the thing running to drive it home...also the brakes were shot from sitting so new Brembo Rotors, pads, shoes and brake hardware was installed just a couple of hours ago... tomorrow the windows will be tinted, the tail lights will be tinted and a detailed bath to remove the build up of dirt n grim in all the door and trunk jams and the edges...got to clean it well before i buff it out!!! Oh...and the heater box has to be dropped and removedand cleaned!!!... hopefully the last mouse nest that is in the car!! I can't even turn on my heater or defoster!!!! I hear...clunk, clunk, clunk...Ewww!!!

yes it is a jdm motor but not one to be proud of or anything, it is a lower displacement of the 5s.

poor engine, it looks like it was stored in a salt mine. but it sounds like you are well on the way to restoration. you should definatly look into a 3S-GTE swap. if you are putting that much effort in the interior. spend some more $$$ for a good engine upgrade

just though I'd add a 3sfe pic

theres a bit of difference between them

^ I guess 3S series engines all have the same intake manifold, it looks the same as the 3S-GE.

3rd gen 3sge coils over the head for the acis, vvti 3sge is a bit more similar, but i think is bigger and has velocity stacks inside

That 3sfe intake manifold looks like the 5sfe intake manifold. gen 1 3sge has almost the same size runners with tvis and side feed. Gen 2 and 3 non beams 3sge has short runners to the acis and then over the valve cover. Beams is a very distinct intake manifold.

It's a Toyota engine nonetheless and you can bet you will have motor for a wile