My check engine light came on yesterday. I reset it today during work and it came right back on.

I checked under the hood and found:







Here is where it is in the engine bay:


Can someone help me figure out how to fix this? I don't see a way to pull the connector apart to re-solder.

Right now all I can think to do is try to get another connector and just splice in my wires. I def don't want to go to the dealer.. and usually our junk yards don't have 6gc's...

Anyone here have one I could get ASAP?


Thanks!

This post has been edited by Jaws4God: Jun 17, 2009 - 5:04 PM

ahhh the throttle position sensor, the connector does come apart... off the top of my head... i think you just put a pin in the front and lift the tab and push the receiver out the back

This post has been edited by pittfirefighter: Jun 17, 2009 - 5:16 PM

should be the same clip on a camry?

pitt nailed it on the head.
you can get one from a junk yard and wire it in, or PM dr tweak, he can get the connector itself for ya if you want to buy it new.