I got a Cold Air Intake kit for my 95 GT vert and was wondering if someone ran into this issue. It has a hole for the crankcase vent but the oem goes from the crankcase to the throttle housing. My question is should I route the hose from the crankcase to the cold intake hole in the pipe and plug the throttle housing hole or should I just plug the the hole on the CAI pipe?

Any suggestions
5sfe

Note the kit has two holes one for the sensor and the other for the crankcase

This post has been edited by tt966g: Jan 21, 2009 - 2:54 PM

that hole is probably for the intake air temp sensor

if you look at your intake box iirc the sensor is plugged in there.

The kit has two holes one for the sensor and one for the crankcase

>
The kit has two holes one for the sensor and one for the crankcase

>


The kit has two holes one for the sensor and one for the crankcase

well then, just plug up the hole for the crankcase vent on the CAI. Leave the hose going to the TB. Its not that big of a deal.

I don't think it really matters.. I left my hose from crankcase to tb.. then plugged the one hole with my air temp sensor.

>

Plug it

-Doc