Noticed it today when I was just cruising around town doing errands. At a low speed when I brake to a stop I hear a clunk that sounds like its underneath me. Or when I am just moving slowly in 2nd gear I can hear in go clunk, clunk, clunk ect. I also get a shake at high speeds which is random, its there sometimes and others its not. could this be a Axle, ball joint, control arm? Gonna have to take it off the road till I figure its safe to be drivin the thing!! Hope its not motor mounts or the tranny mount!

This post has been edited by CelicaGTS94: Sep 16, 2008 - 12:56 PM

CV Joint maybe

wheel bearing is my guess

well the clunking is irrelevent, on my way to work yesterday, the drivers side started to really clunk and bang, and I managed to make it to my parents place, then noticed someone had either tried to steel my rims or removed 4 lugnuts as a joke, damn near had the wheel come off on the highway!! So car is parked till I get locknuts, ordered them today!

ahh lol, thats dumb.. put those nuts back on and no more clunking??

well hope so, but the clunk originally came from the other wheel ( Passengers side) I checked the lugbuts there too they are fine, so not sure car is still parked. I should be back on the road this week. Then we will see if the Pass side still has a problem. The wheel that almost came off was the drivers side front. Still think a ball joint or something is bad on the other side though. wil have to wait and see!

>

On your break pads, there are clips. It sounds like one of these clips has come off / loosened. I had the same problem when i did my DS rotor & Pref. Pad conversion. It clunks in compliance with the revolution of the wheel, Yeah?

Act like your're doing a break job, (Yes, take them out) and re-set them into the caliper. Check the cilips for damage, And if needed, get some clip-clap grease from your local auto joint.