I remember someone posted a pic of their cutom CAI and it was sweet. It was custom made piping. Anyone remember who, or is this you?

It was not me...but...



custom baby!

This post has been edited by Kwanza: Sep 10, 2003 - 4:29 PM

I custom make them, check the website www.evilspeed.com. I'm a little slow getting them made right now due to my job, but they're great quality, and they make more power than any other intake available for the car. I have many satisfied customers.

here is mine, did decent job and works good

Those two are nice. I'm looking for one on a GT.

hey both of those intakes are nicely done...and so is the one on evilspeed.com-Hey spedtoe do you know around how much performance ups..did the intake do and that cat.?

hey doodiehead!! whered you get the piping off of? was it a modified civic CAI? or what?

-K2_Celica+Sep 26, 2003 - 2:04 AM

-gh0st_d0g+Sep 26, 2003 - 1:21 PM

i bought the u bend piping off of jcwhitney, the how-to on making the cai didnt work for me, i only used 2 pieces, but i cut the same measurements
edit:awesome thing about my 2 piece cold air is that it can be cai or short ram, i just take off the upper piece, but i dont wanna keep the short ram on bc i dont want to drill another hole for the sensor

This post has been edited by DoodieHead: Sep 28, 2003 - 2:13 AM

JC Whitney can't do it in aluminum tho!!! >>

I haven't dynoed the intake or the exhaust but together they should make in the neighborhood of 15-20hp. The only power mods I have are SAFC (*sold*), pulley, intake, and exhaust and my car is making about 140 at the crank (based on acceleration data and 1/4 mile trap speeds). The pulley is supposedly 8hp, so the intake, exhaust and tuning account for the other 17. These are all educated guesses, but they should be pretty darn close. The intake and the exhaust lighten the car by almost 25lbs also.