>>This post is about fitting the 619GL onto the double din slot>>
So here's the Lilliput 619 touch screen:
The whole LCD assembly can be forced into between the 2 clips on the panel, but the top hits the air-vent (about 5mm too long).
And the bottom is also too long (about 10mm over):
So, instead of fitting this as is like pittfirefighter did with his 629, we'll have to do some cutting
First we'll have to break the warranty and take this thing apart:
From my measurements, I'd have to cut the case by following the existing gutter on the front casing. Not only it'd be a perfect fit, I also get to retain all the screw holes on the front casing:
I went to Home Depot a bought a $5 hacksaw. Oh, wear a mask or something because it smells when cutting the plastic. After the cut and a little filing, I got the front case to look like this:
See, perfect fit
! Instead of taping it or whatever, I decided to super glue it onto the panel:
Since all the screw holes are still there, I can just mount the monitor the way it came from the factory:
And the back casing, I also need to cut the top and the bottom, and some of the sides to make clearance for the center panel clips:
Connected all of the wirings and mounted the back panel. As for the buttons on the bottom, I just taped it on the back of the casing later on:
You like it?
This post has been edited by tomazws: Apr 12, 2010 - 3:13 AM
So here's the Lilliput 619 touch screen:
The whole LCD assembly can be forced into between the 2 clips on the panel, but the top hits the air-vent (about 5mm too long).
And the bottom is also too long (about 10mm over):
So, instead of fitting this as is like pittfirefighter did with his 629, we'll have to do some cutting
First we'll have to break the warranty and take this thing apart:From my measurements, I'd have to cut the case by following the existing gutter on the front casing. Not only it'd be a perfect fit, I also get to retain all the screw holes on the front casing:
I went to Home Depot a bought a $5 hacksaw. Oh, wear a mask or something because it smells when cutting the plastic. After the cut and a little filing, I got the front case to look like this:
See, perfect fit
! Instead of taping it or whatever, I decided to super glue it onto the panel:Since all the screw holes are still there, I can just mount the monitor the way it came from the factory:
And the back casing, I also need to cut the top and the bottom, and some of the sides to make clearance for the center panel clips:
Connected all of the wirings and mounted the back panel. As for the buttons on the bottom, I just taped it on the back of the casing later on:
You like it?
This post has been edited by tomazws: Apr 12, 2010 - 3:13 AM
-TomazWSwww.tomazws.com
The screen is auto on/off and the laptop is auto wake up/hibernate.
.
