Has anyone ever replaced the seal on the spraying end of the injector that comes in contact with the head? Not the o-ring that goes into the fuel rail, the other end. I just bought a seal kit however the seal on the bottom is alot looser than the factory. I don't want air to leak in. However, it's a rubber seal. I think when I tighten the fuel rail it will push against the rubber and seal fine. Anyone ever done this?

bump?

your post seems very lonely here. i haven't tried this yet but i'll appreciate it if you can post a picture showing your fuel rail o ring kit, and fuel seal to see that we are on the same page.

This post has been edited by jackmorse: Nov 7, 2009 - 6:51 AM

This is from 2 yrs ago bro, but welcome to the site.... What part of Phoenix? I lived out in Surprise for a while.