Anyone have a full-size outline/template of the Cooling plate? I want to make a some changes to the design, but it would jump start me if I could get the current design to work from.

Would be willing to look into getting these made if people like my design.

PM for email to send scans to. Please let me know if this would infringe on anyone's active IP.

Thanks

If someone could just trace the cutout for the latch mechanism, that is all I really need so I can put a piece of cardboard down and trim to fit(this will be a template, I will not be using a cardboard cooling plate.)


Thank you!

Someone help him out.

Just take a piece of cardboard and lay it over. Using a blade cut down through the board around the latch. Then extend out from there till everything clears properly. Do the same for everything else.


For drilling spots on the screws. Just measure out how far in they are and draw up your spot.

>

I was feeling lazy, guess I'll just go ahead and do it this way, or post a WTB