Hey,
I have the OEM Fogs from the GT-four but since I'm using my crashbar they won't bolt up correctly. Any ideas how to mount them? Im thinkin about somehow glueing them into the grill of the gt-four bumper..
Any suggestions would be helpful.
-Rob
Isn't there any way to redrill the holes and relocate them on your current crashbar so they sit in the same location?
This post has been edited by Kadett: Jun 17, 2007 - 12:44 PM
JDM Powerplant installed, BPU coming very soon!
it looks like my crashbar sits up a little higher than the gt-four If I drill holes and attach with the brackets the fogs are too high up and don't line up with the holes in the grille.. I cut a bit off for the bumper to fit.
Use washers/rings and long bolt + nut to make it work. Just need to know how many rings it would take.
JDM Powerplant installed, BPU coming very soon!
Ahh, I'm retarded. Thanks !
how much did the oem gt4 fogs cost? if you don't mind me asking..
----------------------------------------------------------------------------------------------------------------------------------------------------------------
I'm sure they're pretty pricey. They were already on the bumper that I bought from Jarco. I paid 395 for the complete bumper with all the grills and the fogs.
Like Rbrt says, the best way to get them is to find someplace thats imported the entire front end and to just buy them there. Also, if you are able to get the st205 crashbar as well, they just bolt right on, really easy to install. I got the crashbar and foglights for $200 (not to jack the thread).
psalm 69
hey well i just bought a pair of fogs for my ST and am wondering where the best place to run wires through the firewall?
I'm going to try and find a st205 crash bar and just take out my modified one...