i was wondering how do you install vis 404 sideskirts for a 97 celica. the bottom of my car where the sideskirts are supose to be placed has 5 holes that are plugged not sure if i use those hole or drill some other hole for my sideskirts anyone that has mounted thier own side skirts or knows how please help me out?=]

mines are only screwed in at the wheel wells.

>




what u mean?

they didn't attach at the bottom. they attached at the wheel well where the mud guards attach.

up, mine has must 2 holes on each end were there screwed into, then there attached to the car all along on top via 3m automotive tape. but also have some epoxy by the back of the door jam because that kept pulling away from the car on both sides (cheepo skirts not exactly fitted)

This post has been edited by creis: Feb 8, 2007 - 5:43 AM

check this how-to, it'll give you some good pointers on installing skirts on a car.

How to install OEM 96+ Sideskirts on a 94-95 Celica

you dont use the bottom holes IF yoru installing VIS side skirts.....try using a heat gun....install one side n heat the other end...if it doesnt work grab a friend n heat teh installed side n push hard on the other end to get it fit.....i didnt got mines installed yet..but thas what i was told to do.....or follow jonmarkos way of installing vis side skirts:

http://www.6gc.net/forums/index.php?showto...42956&st=80

not 56k friendly...

thanks you guys yah helped out alot

It's a good idea to listen to the guys that also have the 404 skirts on the celica. I have also asked that question a few weeks ago concerning installation. I've even read the thread that asian advanced made about installing the 96+ oem sideskirts. I would go by doing it this way but i'm not the one installing my kit so I don't know.

This post has been edited by netrata: Feb 12, 2007 - 10:51 PM