well just about done doing what im doing and a few questions on the wiring harness? what wires do i need to extend to make everthing work. also need question does anybody know where i could get after market axels that will fit out 6gens..been reading dr tweaks topic about stop extending our wire and if im missing anything please tell me, but it doesn't say anything about which wires to extend.. also where could i get a down pipe for the ct20 turbo...ebay doesn't have any im looking for..it be great for your guys help..
runnin-low

>


its kind of one of those things where you have to have the motor in the car, unwrap the harness and figure out what part you want to extend.

well its on the motor mounts and all but nothing is pluged in yet haven't had time..just wanna know hting before everhting goes downwards..

ive never seen an st205 harness, so its hard to tell. from what i hear, it mostly plugs right in, but you probably have to track down and rewire a few small things to get it to run. i dont know how much specific info youll find on it, becasue most of the people use a st185 motor/harness.

You have the engine in the engine bay but haven't connected any of the wiring loom?
Gary

The 205 harness with the 3rd gen motor should plug into everything as is, the only piece that doesnt fit is the connection through the firewall - which is why people extend them.

Axles depend on which trans your using. I think ATS makes a replacement for the MR2 CV's, though the stock axles are quite beefy.