rocky2006

#1

on gt3, for na tunup stage 1 on a ST202 celica it says: "Boosts the power on non-supercharged engines by adjusting the ignition and valve timing and installing thinner head gaskets for higher compression ratio. The exhaust manifold is also replaced. Peak power is enhanced without affecting low-rpm torque." can i do this on my at200 without getting the header? ive never seen this brought up before so i was just wondering if a 7afe could get some power this way.

slipgun

#2

Sure... but its not gona be cheap.

Hanyo

#3

your not gonna see as much gains as a performance motor..

the flow design of the 7afe is just not good.. so no matter how you tune it.. it will not give you good power.

bloodrain

#4

why dont you keep saving your "credits" and buy a suzuki escudo?

---

To live, is to sufferTo survive, thats to find meaning, in the suffering....

rocky2006

#5

well the only thing that would cost money is the gaskets. i guess it's not worthwhile on the lil 7afe. thanks for the replies.

lagos

#6

do it in the game. dont do it in real life. >>

---

15PSI - 30MPG - Megasquirt Tuned

Hanyo

#7

i always wanted to do a high compression engine like edo's car..

but i just dont have to knowledge to attempt anything yet. >>

CheesyLobster

#8

Header is where the most hp is at from the things you listed.

94ST2

#9

Did we ever get the numbers on edo's na 7afe?

macavely

#10

do it ..... and silence the unbelivers...

---

[TeamNJCT

edo17982

#11

-94ST2+May 21, 2005 - 10:08 AM

QUOTE(94ST2 @ May 21, 2005 - 10:08 AM)

Did we ever get the numbers on edo's na 7afe?
[right][snapback]289894[/snapback][/right]

Yes, Doggy will get my emanage tuned in few days and then we'll finally get that dyno so we'll know what a NA 7AFE can push out >>

rocky2006

#12

try to get the numbers up here asap >>.

Dr_Tweak

#13

-rocky2006+May 20, 2005 - 12:56 AM

QUOTE(rocky2006 @ May 20, 2005 - 12:56 AM)

on gt3, for na tunup stage 1 on a ST202 celica it says: "Boosts the power on non-supercharged engines by adjusting the ignition and valve timing and installing thinner head gaskets for higher compression ratio.  The exhaust manifold is also replaced.  Peak power is enhanced without affecting low-rpm torque."  can i do this on my at200 without getting the header?  ive never seen this brought up before so i was just wondering if a 7afe could get some power this way.
[right][snapback]289216[/snapback][/right]

What GT3 needs in an engine swap option. >> A 4AGE swap will be cheap and easy enough, and give you lots of power for the money.

-Doc

---

-Dr Tweak, 6GC's resident engine swap wiring expert extraordinaireClick here to see my swapsdrtweak@phoenixtuning.com