Yes i seen it discussed in a few topics up buuut.

First question, I went to disconnect the sway bar link from the control arm the and where you put in the Hex wrench is stripped to ****. Any suggestions? Cut the bolt and get a new link? Just disconnect the sway bar from the link all together?

Question two, the cotter pin broke off inside bolt when i was disconnecting the tie rod end =X. It broke off enough to where i got the nut off anyways. Just drill it out maybe?

Well to answer my own question #1 looks like im cutting the sway bar links off, all 4 of the holes are stripped and my hex wrench just kinda rolls around in there and does nothing =/

-Skate4mindgame+May 11, 2005 - 11:28 PM

gahh,
I know i'll be in your shoes when i go to do this. Maybe if i start coating penetrating grease and wd40 now i'll help myself a bit but who knows. I don't have that hex wrench im sure of it and i should probably order those bolts from napa now just incase. That is if i can get them through napa.

Hey buddies, found this thread in my search for the sway bar.. Been wanting to hear your thought about heelwig sway bar kit.. pros and cons? any onther brands in the market?

Thanks!

This post has been edited by DanGrey: Nov 29, 2010 - 7:25 PM

>

use PB Blaster, works wayyyyy better!