Over 1M Posts • 84K Topics • 9K Authors

Possible FS: 3sgte Celica - 6G Celicas Forums

Topic #17656 12 posts Started by celica3sgte
It is true. I may be selling my celica and start over a few years from now. But as for now,,,,I'm flat broke. My celica is too nice to drive around and my civic just died on me. So I'm throwing the offer out there to see if anyone is seriously interested. Check out my profile for pics and I can email you a ton more. I also have video I can send you. I've put around $26,000 into the car and I'll make a list of mods below. There is about $20,000 of physical parts on the car now. The paint is GM arrival blue with a black base coat, and with flake. I ran a 13.7 in the quarter mile and should have been in the low 13's with the old turbo. It needs bigger injectors, the mr2 tranny, and an aftermarket computer and will run low 11's. The new turbo is good for 360 at the wheels. Email me at swapd3s@yahoo.com if you are seriously interested. The 3sgte has 50,000 miles on it, new timing belt, water pump, fuel, and ignition components. The car has 160,000 miles.


http://www.picturetrail.com/gallery/view?p...351&uid=2753011

1994 Celica ST $3200
Garrett T3/T04e Turbo kit $2000
Precision Brake Custom Big Brake kit $1600
Paint Job $2500
2nd 3sgte JDM Motor Swap $3500
Erebuni Wing $400
Veilside Body Kit $1000
System (2 8" kicker compvr subs, $1100
2 Alpine Amps, JL audio xr 525 csi components,
custom trunk, sony xplod 5480 deck)
19" Motegi DPK(custom painted) $1800
Spearco FMIC setup $800
Rear disc brake conversion $350
KYB struts $150
Tenzo R evolution seats $500
Tenzo R steering wheel $200
Tenzo R Accessories $100
Sparco 4 point harness $200
4 Gauges $250
Exhaust setup(resonator, $1000
high flow cat, flex pipe, apexi n1
muffler)
Greddy Profec B II Boost Controller $300
Greddy Turbo Timer $100
HKS SS Blow off valve $250
5.5" Lcd flip out TV $500
PS2 $150
Diamond Plated Floor Mats $100
5th Gen Celica Mirrors $150
CO2 purge and intercooler sprayer $250
Ground Control Coilovers $350
Clear turns, Clear side $50
Polished engine parts
Custom seat brackets
Custom Motor mounts
Battery Relocation
Custom Fiberglass Dash
$22,900 total

I didn't include any labor prices in this total, which comes to over $1,000

This post has been edited by celica3sgte: Oct 23, 2004 - 4:35 PM

wrong forum, and post a price & pics.

Also, you say 26K but I see only 20K because you cant count the car as "parts"

This post has been edited by Supersprynt: Oct 23, 2004 - 1:17 PM


MyFlickrMyeBay_Perpetual Aperture_
Are you still in Ohio? If you are, I'd be interested. What are you looking to get?

Sometimes we live to beat the odds.-Ryanaim: rkgreen04
Cool car, it actually like it and it has a body kit. (is hell freezing over?) But I think the price quoted some some of those parts are bit high.

Free bump for a cool celi

NASA/SCCA RX-7....currently under the knife92 Civic hatch B16 - Sold10th anniv RX-7 - RIPThe Slow Celica - Sold...and then crushed crushed due to street racing.Quote from Seinfeild: George's Boss reading a magazine: "People magazine's most beautiful people. Oh and a Celica...nothin wrong with that!"
Thats all pretty high prices concidering all those parts are used and you rounded the "new" price of them up.

Pics would help you sell the car faster... Ebay would help even more.

Member of Team 5sfTe
Wow guys, I said I might be selling the car if I get a good offer. I listed what I put into the car and what I paid for the parts. I just moved down to Florida. I'm not putting a price on it. I'd like to see what a buyer would be willing to put on it. If it's the right price I'll probably sell it b/c at this point I don't have much of an option.

This post has been edited by celica3sgte: Oct 23, 2004 - 2:28 PM
Wow, whoever did your exhaust and LCD screen ripped you off.
The muffler was $250, 2 pieces of flexpipe $120, resonator $50, high flow cat $100, 3" stainless steel piping was $175, and the downpipe was $300 and flanges. The performance shop that welds stainless and ceramic coating charges $60 per hour, which isn't included in with the price I listed.
Is that a bill "no cash" turbo kit? If not, who did the exhaust manifold?

QUOTE(lagos @ Jul 10, 2006 - 1:55 PM) [snapback]454118[/snapback]i know your trying to do the right thing for your motor, but this is one of those times where you should just trust the guys who have had their swaps for a while and have done a ton of research into this.
-jgreening+Oct 23, 2004 - 8:49 PM
i'd give ya $14,000.