So, the speed sensor from the 7afe has an electrical plug and the one in the 3S is mechanical. how did you swappers solve this problem?

the good news is, i had my mechanic open up the tranny today to check on the clutch and 2 hours later i stopped in to see a shiny blue Cusco clutch assembly complete with lightened flywheel. but on the other hand, they had to break the starter just to pull it out of the engine...no biggy

-gtfc115+Oct 18, 2004 - 12:00 PM

it wasnt his fault...the starter was stuck for some reason

the 3sgte sensor is electronic, so is the 6th gen one.. just use the sensor thats already mounted to the tranny u will be using and it should just plug right in

does it make a difference to say that i'm swapping from a jdm SW20 clip and not an alltrac

here is a pic of both...on top os the 3sgte out of the mr2, the bottom is my old 7afe


This post has been edited by gtfc115: Oct 18, 2004 - 9:58 PM

anyone?

Anyone?

you? you?

(bump)

ive never done an mr2 swap, but i think you are going to need an st185 wiring harness. then your stock sensor should just plug in.

know of anyone selling theirs?

Keoni on celica.net said he had a camry sensor that he thinks would work. does anyone know about this? if its the same tranny then i dont see why it wouldnt work, as long as it is electronic.