OK I had a thread goin about my alarm issue,, well long story short I have no power to my drivers side door switch now.. switched the diodesaround and passenger side still works but cannot get power to my drivers sid3e switch,, ahhh any ideas???

Did you install the alarm yourself?

yup sure did.. thats not a problem done lots of em just had an issue with the lighted entry and accidently (not paying attention= talking) ****ed up and shorted out something.. now have no power to my door switch.. the wires are confusing on this too,, book says red/white,, at kick pannel it is red/white,, at switch red/white but at the connection just indside the rear pannel it is red/yellow,, can't find a red/yellow leading to the kick ,, have to pull the whole cluster from the door switch ahead out and chase it down,, was hopeing some one else knew so i didn't have to....

what kind of connections are you using... if you used butts any chance you caught some insulation and have a bad connection

NO there is no connection I made that should affect it,, I disconnected and soildered back up still nothing....

t96f... check your pm