hey everyone, as most of us know i am still having crazy problems getting my swap to run. we have pretty much narrowed the problems down to the harness which was made by mike (qatar11). i have e-mailed him numerous times for help but I only get reponses from him that say he has no time to help me at the moment. I got one week left to pan this out or I miss another show. If i miss this one i may lose my sponsor (cobeau racing). I need any Jdm Wiring diagrams , the problem lies in the ignition. wiring for coil, injectors, fuel resistor, ignitor, and distributor are needed. please help.

for info on the problems i am having , go to the thread "i need help fast" >>

Try this. Wiring info thread This is about all the wiring info we could get togeather, with a lot of thanks to Lagos... hope this info helps..

thankyou all for any help you have given, i have found my problem, Mike (qatar11) had 2 of the distibutor wires reversed at the ecu, switched them around waaaalaaa, engine idles, revs to red line , no hesitation , smooth idle, run great cant wait to get it out and drive it, just gotta finish hooking up the nitrous, blow off valve and front mount intercooler and i should be ready, thanks again!!!!!
PS, i found this without mikes help, he still has not replied any help at ALL....
>>