hey wuzap, i just got a ps2 and ordered in a flip out tv. im having a problem trying to figure out where to mount the ps2, it doesnt fit in the glove box, where do i put it?

ps2 in under the passnages seat and the tv in the glove box

ps2 will fit under the pass seat but, it wont have that much room. you should put it in the back of the car, and get extentions for the controlers. leaving the ps2 under th seat will just cause problems with ur ps2....... not enough room for the cd door to open. an soon there after the ps2 will start to malfuntion because it was sqweezed under a seat.

mount it in the back...... mine got a messed up from being under the seat.

hope that helps
defgeph

Trunk, and extend the CD tray to the glove box, the controllers to the change area, etc etc >> It's some work, but it's the pro way to do it.

Dude why not just take out your pass air bag and mount it to the top of the lid. Then use like a push button magnet to make it go up and down?

i think if you messed around with the inner glove box compartment...you could fit it in there...

Personally, I will NEVER EVER EVER take out any of the airbags in my car. Not to fit a PS2 there, not to put a sporty steering wheel there. never.

I got a question how hard is it to put a tv in the glove compartment and to hook a playstation and tv up to the battary cuz my battary suxs and i just got it. should i get a new on or a 2nd one.

ok this is the best way in my opinion(cause i did it this way lol)
#1) put it in glove box, you will need to cut the back of the box (when you open it its the top of it) so it can slide in. then since that section is cut out you can easily run the wires into the center consol
#2) trick way to do the controllers is to run the controller wires through the back of the glove box then around into the center consol and out the box that is inbetween the seats and they can hide in there. this way all you have to do is open the lid pull them out and close the lid agian no wires to clutter up your passenger space at all and its a nice sweet clean look. you'll have to cut a 2" by 1/2" rectangle in the box so you can slide the wires through.
if you want i can show you pics of how i did it if your interested in that way

-shid+Apr 8, 2004 - 11:43 AM

I was thinking put a tv in the glove box, not sure what size and how to mount it. then putting the playstation right behind the center console standing up stuck in place somehow dotn know how to that yet. Then run the controllers up under the seats.

i figured out were to put it, i made a custom mount right under the dash in the passenger side. it looks good, i dont have to cut the glove box, or go to my trunk to play it, plus u cant see it from outside the car.

the coooooles way IMO to get the job done, would be make a bezel for the tray and control/memory card slots, and put them underneat your CD player... do it up all nice... now that would be tight...

How do u move the cd tray?

yeah id suggest cutting the glove box

You have to open up the PS2, find the connectors, buy extensions, soder, etc

is it hard i think i want to but tyhe cd tray in a differnt spot give it a try. Butim going ot wait until they are cheaper or i get a new system like PS3

It IS hard, if you have no knowledge of electronics or computers- it's difficult/annoying if you have a lot of knowledge of electronics/computers- the PS2 insides are a bitch to work with.

and I don't recommend trying it with a PS3- you might break it while trying and waste money >>

no doubt its hard....

no no no im would try it with the ps2 whne i get a ps3